Discussion
Home ‣ Electronics ‣ Special-Purpose Op-Amp Circuits Comments
- Question
Typical isolation amplifiers use optical coupling.
Options- A. True
- B. False
- Correct Answer
- False
- 1. OTA stands for Operational Transistor Amplifier.
Options- A. True
- B. False Discuss
- 2. Clampers are often called peak detectors.
Options- A. True
- B. False Discuss
- 3. Isolation amps are named as such because they are sealed for protection from outside environmental damage.
Options- A. True
- B. False Discuss
- 4. In order to sustain oscillations in a feedback oscillator, the gain should be _________ so the product of Av × B equals_______.
Options- A. reduced, one
- B. reduced, less than one
- C. increased, more than one
- D. increased, much greater than one Discuss
- 5. The gate-source junction of a JFET must be ________ for proper linear operation.
Options- A. forward-biased
- B. reverse-biased
- C. either forward-biased or reverse-biased
- D. neutral Discuss
- 6. One of the principal areas of application for an isolation amplifier is power plant instrumentation.
Options- A. True
- B. False Discuss
- 7. The main purpose of an instrumentation amplifier is to amplify small signals riding on large common-mode voltages.
Options- A. True
- B. False Discuss
- 8. An isolation amplifier provides ac isolation between input and output.
Options- A. True
- B. False Discuss
- 9. An OTA is primarily a current-to-voltage amplifier.
Options- A. True
- B. False Discuss
- 10. To construct an instrumentation amplifier, two op-amps and seven resistors are needed.
Options- A. True
- B. False Discuss
Special-Purpose Op-Amp Circuits problems
Search Results
Correct Answer: False
Correct Answer: False
Correct Answer: False
Correct Answer: reduced, one
Correct Answer: reverse-biased
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Correct Answer: False
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.