logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Transformers Comments
  • Question

  • For mutual inductance to occur, the two coils must be at right angles to each other.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    • Transformers problems

    Search Results

    • 1. 

      In the given circuit, Maximum power is being transferred to the load.


    • Options
    • A. True
    • B. False
      • Discuss
    • 2. A transformer that has 700 turns in the primary and 35 turns in the secondary has a turns ratio of 20:1.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. If voltage is stepped-up to the secondary, current will be stepped-down by the same amount.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. An open secondary winding of a transformer will cause the primary current to be nearly zero.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. The secondary voltages produced by a center-tapped transformer are equal in amplitude but 180° out of phase with respect to the center tap.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. A transformer turns ratio of ________ will be needed to match an output impedance of 5 kΩ to an 8 Ω speaker.

    • Options
    • A. 5:1
    • B. 8:1
    • C. 25:1
    • D. 625:1
      • Discuss
    • 7. ___ is the concept of one coil inducing a voltage into another coil.

    • Options
    • A. Electrical isolation
    • B. Self-inductance
    • C. Mutual inductance
    • D. Coefficient of coupling
      • Discuss
    • 8. 

      The secondary current is _____ in the given circuit.


    • Options
    • A. 1.9 mA
    • B. 7.5 mA
    • C. 30 mA
    • D. 60 mA
      • Discuss
    • 9. A step-up transformer will ___ to the secondary.

    • Options
    • A. increase the current
    • B. increase the voltage
    • C. increase the power
    • D. decrease the voltage
      • Discuss
    • 10. ___ occurs in a transformer when some of the primary flux lines pass through the air instead of the core.

    • Options
    • A. Hysteresis loss
    • B. Magnetic flux leakage
    • C. Winding resistance
    • D. Winding capacitance
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.