logo

CuriousTab

CuriousTab

Discussion


Home Electronics Series-Parallel Circuits Comments

  • Question
  • In the given circuit, the total resistance (RT) between points A and B equals _____. 10 ? 100 ? 900

    In the given circuit, the total resistance (RT) between points A and B equals _____.


  • Options
  • A. 10 Ω
  • B. 100 Ω
  • C. 900 Ω
  • D. 1,010 Ω

  • Correct Answer
  • 100 Ω 


  • Series-Parallel Circuits problems


    Search Results


    • 1. Series components in a series?parallel circuit may be in series with other _______________ components, or with other _______________ components.

    • Options
    • A. individual, combinations of
    • B. series, parallel
    • C. parallel, series
    • D. shunt, parallel
    • Discuss
    • 2. 

      In the given circuit, the current flowing through R3 equals ______.


    • Options
    • A. 10 mA
    • B. 21.11 mA
    • C. 90 mA
    • D. 100 mA
    • Discuss
    • 3. If a Wheatstone bridge is balanced, its output voltage is ____.

    • Options
    • A. the same as its input voltage
    • B. very high
    • C. dependent on the unknown resistor value
    • D. equal to 0 V
    • Discuss
    • 4. The loading effect of a voltmeter can be ignored if ____.

    • Options
    • A. the measured voltage is very high
    • B. the measured voltage is very low
    • C. the meter's resistance is at least 10 times greater than the resistance across which it is connected
    • D. the meter's resistance is at least 10 times less than the resistance across which it is connected
    • Discuss
    • 5. If the output voltage of a certain loaded voltage divider is 12 V, the output voltage might decrease when the load is removed.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. When a load is connected to a voltage divider, the total resistance of the circuit will ________.

    • Options
    • A. increase
    • B. decrease
    • C. remain the same
    • D. double
    • Discuss
    • 7. If four 10 kΩ resistors are in series with a single 20 kΩ resistor and one of the parallel resistors shorts, the voltage across the other parallel resistors ________.

    • Options
    • A. increases
    • B. decreases
    • C. remains the same
    • D. drops to zero
    • Discuss
    • 8. 

      In the given circuit, the voltage at point A equals ______.


    • Options
    • A. ?10 V
    • B. +1 V
    • C. +9 V
    • D. +10 V
    • Discuss
    • 9. ___ is often used to analyze multiple-source circuits.

    • Options
    • A. Thevenin's theorem
    • B. Superposition
    • C. Kirchhoff's law
    • D. Ohm's law
    • Discuss
    • 10. 

      In the given circuit, the voltage dropped across R1 equals _____.


    • Options
    • A. 1 V
    • B. 9 V
    • C. 10 V
    • D. 19 V
    • Discuss


    Comments

    There are no comments.

Enter a new Comment