logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Bipolar Junction Transistors (BJT) Comments
  • Question

  • Transistors are controlled to operate as a switch or to operate as a variable resistor.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 

    • Bipolar Junction Transistors (BJT) problems

    Search Results

    • 1. A bipolar transistor has three leads: the base, collector, and emitter.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. A decrease in base current of a C-E amplifier causes the voltage measured between the emitter and the collector to increase.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. In this analog amplifier the input is in phase with the output.


    • Options
    • A. True
    • B. False
      • Discuss
    • 4. A common-emitter (C-E) is so called because the emitter is connected to both the input and output signals.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. The two most common types of analog-to-digital converters discussed in this chapter were the ______.

    • Options
    • A. linear converter and the analog converter
    • B. linear converter and the successive approximation converter
    • C. flash converter and the analog converter
    • D. flash converter and the successive approximation converter
      • Discuss
    • 6. In a common-base (C-B) amplifier, the output is 180 degrees out of phase with the input.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. In a BJT, the collector current is approximately equal to the base current.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. If this circuit were used in a digital circuit, it would be a NOT gate.


    • Options
    • A. True
    • B. False
      • Discuss
    • 9. With a common-collector (C-C) amplifier the input is applied to the base and the output is taken from the emitter.

    • Options
    • A. True
    • B. False
      • Discuss
    • 10. A transistor used in a digital circuit will have two operating states, which are cutoff and saturation.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.