logo

CuriousTab

CuriousTab

Discussion


Home Electronics Bipolar Junction Transistors (BJT) Comments

  • Question
  • A bipolar transistor has three leads: the base, collector, and emitter.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 


  • Bipolar Junction Transistors (BJT) problems


    Search Results


    • 1. A decrease in base current of a C-E amplifier causes the voltage measured between the emitter and the collector to increase.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. In this analog amplifier the input is in phase with the output.


    • Options
    • A. True
    • B. False
    • Discuss
    • 3. A common-emitter (C-E) is so called because the emitter is connected to both the input and output signals.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. The two most common types of analog-to-digital converters discussed in this chapter were the ______.

    • Options
    • A. linear converter and the analog converter
    • B. linear converter and the successive approximation converter
    • C. flash converter and the analog converter
    • D. flash converter and the successive approximation converter
    • Discuss
    • 5. RTDs, strain gauges, and pressure transducers are _____ devices.

    • Options
    • A. resistive
    • B. inductive
    • C. capacitive
    • D. solid-state
    • Discuss
    • 6. Transistors are controlled to operate as a switch or to operate as a variable resistor.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. In a common-base (C-B) amplifier, the output is 180 degrees out of phase with the input.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. In a BJT, the collector current is approximately equal to the base current.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. If this circuit were used in a digital circuit, it would be a NOT gate.


    • Options
    • A. True
    • B. False
    • Discuss
    • 10. With a common-collector (C-C) amplifier the input is applied to the base and the output is taken from the emitter.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment