CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Discussion
Home
‣
Electronics
‣
Bipolar Junction Transistors (BJT)
Comments
Question
A decrease in base current of a C-E amplifier causes the voltage measured between the emitter and the collector to increase.
Options
A. True
B. False
Correct Answer
True
Bipolar Junction Transistors (BJT) problems
Search Results
1. In this analog amplifier the input is in phase with the output.
Options
A. True
B. False
Show Answer
Scratch Pad
Discuss
Correct Answer: False
2. A common-emitter (C-E) is so called because the emitter is connected to both the input and output signals.
Options
A. True
B. False
Show Answer
Scratch Pad
Discuss
Correct Answer: True
3. The two most common types of analog-to-digital converters discussed in this chapter were the ______.
Options
A. linear converter and the analog converter
B. linear converter and the successive approximation converter
C. flash converter and the analog converter
D. flash converter and the successive approximation converter
Show Answer
Scratch Pad
Discuss
Correct Answer: flash converter and the successive approximation converter
4. RTDs, strain gauges, and pressure transducers are _____ devices.
Options
A. resistive
B. inductive
C. capacitive
D. solid-state
Show Answer
Scratch Pad
Discuss
Correct Answer: resistive
5. The ______ is composed of a transformer with a movable core, a primary, and two secondaries.
Options
A. LVDT
B. strain gauge
C. accelerometer
D. transformer displacement sensor
Show Answer
Scratch Pad
Discuss
Correct Answer: LVDT
6. A bipolar transistor has three leads: the base, collector, and emitter.
Options
A. True
B. False
Show Answer
Scratch Pad
Discuss
Correct Answer: True
7. Transistors are controlled to operate as a switch or to operate as a variable resistor.
Options
A. True
B. False
Show Answer
Scratch Pad
Discuss
Correct Answer: True
8. In a common-base (C-B) amplifier, the output is 180 degrees out of phase with the input.
Options
A. True
B. False
Show Answer
Scratch Pad
Discuss
Correct Answer: False
9. In a BJT, the collector current is approximately equal to the base current.
Options
A. True
B. False
Show Answer
Scratch Pad
Discuss
Correct Answer: False
10. If this circuit were used in a digital circuit, it would be a NOT gate.
Options
A. True
B. False
Show Answer
Scratch Pad
Discuss
Correct Answer: True
Comments
There are no comments.
Enter a new Comment
Save
More in Electronics:
Alternating Current and Voltage
Alternating Current vs Direct Current
Analog and Digital Converters
Analog to Digital
Arithmetic Operations and Circuits
Basic Op-Amp Circuits
Bipolar Junction Transistors (BJT)
Capacitors
Combinational Logic Circuits
Computer Hardware and Software
Diodes and Applications
Field Effect Transistors (FET)
Flip-Flops and Timers
Inductors
Logic Circuit Simplification
Logic Gates
Magnetism and Electromagnetism
Measurement, Conversion and Control
Number Systems and Codes
Ohm's Law
Operational Amplifiers
Parallel Circuits
Programmable Logic Devices (PLD)
Quantities and Units
RC Circuits
Resistance and Power
RL Circuits
RLC Circuits and Resonance
Semiconductor Memory
Semiconductor Principles
Sequential Logic Circuits
Series-Parallel Circuits
Series Circuits
Special-Purpose Op-Amp Circuits
Standard Logic Devices (SLD)
Testing and Troubleshooting
Thyristors and Tranducers
Time Response of Reactive Circuits
Transformers
Transistors and Applications
Voltage and Current