logo

CuriousTab

CuriousTab

Discussion


Home Electronics Measurement, Conversion and Control Comments

  • Question
  • RTDs, strain gauges, and pressure transducers are _____ devices.


  • Options
  • A. resistive
  • B. inductive
  • C. capacitive
  • D. solid-state

  • Correct Answer
  • resistive 


  • Measurement, Conversion and Control problems


    Search Results


    • 1. The ______ is composed of a transformer with a movable core, a primary, and two secondaries.

    • Options
    • A. LVDT
    • B. strain gauge
    • C. accelerometer
    • D. transformer displacement sensor
    • Discuss
    • 2. The number of bits in a digital word determines the number of digital combinations that will be represented. The number of combinations can be calculated by ________.

    • Options
    • A. raising 2 to the number of bits in the analog word
    • B. raising 2 to the number of bits in the digital word
    • C. multiplying 2 by the number of bits in the analog word
    • D. determining the range of the analog word
    • Discuss
    • 3. A(n) _____ can be rapidly switched on and off remotely by another controlling circuit.

    • Options
    • A. triac
    • B. diac
    • C. RTD
    • D. zero-voltage switch
    • Discuss
    • 4. A triac is different from an SCR because ________.

    • Options
    • A. it can handle large current flows
    • B. it can handle large voltages
    • C. the gate signal can turn off the current flow
    • D. it allows current flow in both directions
    • Discuss
    • 5. A thermistor's temperature characteristic is essentially _________.

    • Options
    • A. linear
    • B. logarithmic
    • C. nonlinear
    • D. geometric
    • Discuss
    • 6. The two most common types of analog-to-digital converters discussed in this chapter were the ______.

    • Options
    • A. linear converter and the analog converter
    • B. linear converter and the successive approximation converter
    • C. flash converter and the analog converter
    • D. flash converter and the successive approximation converter
    • Discuss
    • 7. A common-emitter (C-E) is so called because the emitter is connected to both the input and output signals.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. In this analog amplifier the input is in phase with the output.


    • Options
    • A. True
    • B. False
    • Discuss
    • 9. A decrease in base current of a C-E amplifier causes the voltage measured between the emitter and the collector to increase.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. A bipolar transistor has three leads: the base, collector, and emitter.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment