logo

CuriousTab

CuriousTab

Discussion


Home Electronics Time Response of Reactive Circuits Comments

  • Question
  • It takes ______ for the output voltage in the given circuit to reach its maximum value. 0 s 243.9 µs

    It takes ______ for the output voltage in the given circuit to reach its maximum value.


  • Options
  • A. 0 s
  • B. 243.9 µs
  • C. 1 ms
  • D. 1.22 ms

  • Correct Answer
  • 1.22 ms 


  • Time Response of Reactive Circuits problems


    Search Results


    • 1. The _____ is the time it takes for a capacitor to fully charge or discharge.

    • Options
    • A. transient time
    • B. pulse response
    • C. time constant
    • D. steady state
    • Discuss
    • 2. 

      The output voltage in the given circuit is _____ at the end of the second pulse.


    • Options
    • A. 1.06 V
    • B. 7.56 V
    • C. 3.32 V
    • D. 12 V
    • Discuss
    • 3. 

      If the component positions were switched in the given circuit, the circuit would be an ______.


    • Options
    • A. RL differentiator
    • B. RC differentiator
    • C. RL integrator
    • D. RC integrator
    • Discuss
    • 4. A(n) _____ will decrease the time constant in an RC integrator or differentiator.

    • Options
    • A. open resistor
    • B. open capacitor
    • C. shorted capacitor
    • D. leaky capacitor


    • Discuss
    • 5. 

      After the rising edge of the input pulse occurs, it takes ______ for the voltage across the resistor to decrease to zero in the given circuit.


    • Options
    • A. 0 s
    • B. 68 µs
    • C. 340 µs
    • D. 500 µs
    • Discuss
    • 6. When the capacitance in an active high-pass filter increases, the critical frequency decreases.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. The feedback component in an op-amp integrator is a capacitor.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. A zero-level detector is a type of comparator circuit.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. When used as a comparator, an op-amp is wired in a closed-loop configuration.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. To operate properly, an oscillator requires an external ac input signal.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment