logo

CuriousTab

CuriousTab

Discussion


Home Electronics Operational Amplifiers Comments

  • Question
  • If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 


  • Operational Amplifiers problems


    Search Results


    • 1. If the two inputs to a differential amplifier are exactly the same, then the output is the signal multiplied by two.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. The frequency of a crystal is dependent on how much voltage is applied to activate it.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. An S-R flip-flop is an example of a bistable multivibrator circuit.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. An open feedback resistor in an inverting or noninverting op-amp circuit can cause severe clipping of the output signal.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. Current actually flows into or out of a virtual ground.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. A monostable multivibrator must be triggered.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. The difference between the upper and lower trigger points is called the Schmitt trigger.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. The inverting input is pin 2.


    • Options
    • A. True
    • B. False
    • Discuss
    • 9. A voltage-follower op-amp has the output connected directly to the inverting input.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. This circuit is a bandpass filter.


    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment