logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Operational Amplifiers Comments
  • Question

  • The frequency of a crystal is dependent on how much voltage is applied to activate it.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    • Operational Amplifiers problems

    Search Results

    • 1. An S-R flip-flop is an example of a bistable multivibrator circuit.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. An open feedback resistor in an inverting or noninverting op-amp circuit can cause severe clipping of the output signal.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. Current actually flows into or out of a virtual ground.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. A virtual ground is a ground for current, but not for voltage.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. Changing the input voltage to an op-amp circuit will change its voltage gain.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. If the two inputs to a differential amplifier are exactly the same, then the output is the signal multiplied by two.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity with the input.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. A monostable multivibrator must be triggered.

    • Options
    • A. True
    • B. False
      • Discuss
    • 9. The difference between the upper and lower trigger points is called the Schmitt trigger.

    • Options
    • A. True
    • B. False
      • Discuss
    • 10. The inverting input is pin 2.


    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.