logo

CuriousTab

CuriousTab

Discussion


Home Electronics Operational Amplifiers Comments

  • Question
  • Feedback is used in an open-loop operational amplifier circuit.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 


  • Operational Amplifiers problems


    Search Results


    • 1. Crystal oscillator circuits have a very low Q.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. The ideal output impedance for an operational amplifier is 0 Ω.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. If the two inputs to a differential amplifier are exactly the same, then the output is the signal multiplied by 2.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. If an input signal is applied to the inverting input of an op-amp with the noninverting input grounded, the output signal would be opposite in polarity to the input.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. An inverting amplifier has a phase shift of 180° from input to output.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. An astable multivibrator has two states.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. The feedback resistor adds to the gain of an op-amp.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. It takes 4 µs for the output voltage of an op-amp to rise from ?14 V to +14 V. The slew rate of this op-amp is 3.5 V/µs.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. In a common-mode input to an op-amp, both inputs are connected to the same signal source.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. An op-amp has very low open-loop gain.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment