logo

CuriousTab

CuriousTab

Discussion


Home Electronics RLC Circuits and Resonance Comments

  • Question
  • The phase angle is ______ in the given circuit. 27.6° 62.4° 74.1° 76.1°

    The phase angle is ______ in the given circuit.


  • Options
  • A. 27.6°
  • B. 62.4°
  • C. 74.1°
  • D. 76.1°

  • Correct Answer
  • 27.6° 


  • RLC Circuits and Resonance problems


    Search Results


    • 1. When a parallel tank circuit is used in series with an output load resistor the filter is ______.

    • Options
    • A. low-pass
    • B. band-stop
    • C. band-pass
    • D. high-pass
    • Discuss
    • 2. Series resonance happens when _____.

    • Options
    • A. XC = XC
    • B. XL = XC
    • C. XL = XB
    • D. XT = R
    • Discuss
    • 3. 

      The output voltage at the resonant frequency is _____ in the given circuit.


    • Options
    • A. 0 V
    • B. 557 mV
    • C. 6.08 V
    • D. 6.5 V
    • Discuss
    • 4. A parallel tuned circuit can be used to couple energy from one circuit to another.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. The greater the selectivity, the wider the bandwidth.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. 

      The output voltage at the resonant frequency is ______ in the given circuit. If a 10 kΩ load is connected.


    • Options
    • A. 553 mV
    • B. 5.65 V
    • C. 6.01 V
    • D. 6.5 V


    • Discuss
    • 7. The ___ of a circuit describes the ability of that circuit to respond to certain frequencies while rejecting all others.

    • Options
    • A. bandwidth
    • B. selectivity
    • C. sensitivity
    • D. quality factor
    • Discuss
    • 8. At frequencies well above and below the resonant frequency, the series RLC circuit looks ______ and the parallel RLC circuit looks ______.

    • Options
    • A. like a short, like an open
    • B. like an open, like a short
    • C. inductive, capacitive
    • D. capacitive, inductive
    • Discuss
    • 9. When a parallel tank is used in series with an output load resistor the filter is a(n) ______ filter.

    • Options
    • A. band-stop
    • B. low-pass
    • C. bandpass
    • D. high-pass
    • Discuss
    • 10. 

      The bandwidth is ______ in the given circuit.


    • Options
    • A. 179.28 Hz
    • B. 3.54 kHz
    • C. 4.44 kHz
    • D. 15.85 kHz
    • Discuss


    Comments

    There are no comments.

Enter a new Comment