logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ RLC Circuits and Resonance See What Others Are Saying!
  • Question

  • If the output voltage were taken from across the resistor in the given circuit, the circuit would be

    If the output voltage were taken from across the resistor in the given circuit, the circuit would be a band-pass filter.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 

    • More questions

    • 1. 

      What is the voltage across the capacitor in the given circuit?


    • Options
    • A. 6.8 V
    • B. 11.9 V
    • C. 16.1 V
    • D. 22.9 V
      • Discuss
    • 2. The diode's characteristic curve shows that current increases when voltage increases.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. It takes 4 µs for the output voltage of an op-amp to rise from ?14 V to +14 V. The slew rate of this op-amp is 3.5 V/µs.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. A JFET has 3 terminals: gate, drain, and source.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. If an open capacitor is checked with an ohmmeter, the needle will:

    • Options
    • A. stay on zero
    • B. stay on infinity
    • C. move from zero to infinity
    • D. move from infinity to zero
      • Discuss
    • 6. The resistive track of a rheostat or potentiometer can be classified as having either a linear or tapered resistance.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. When a circuit consists of a capacitor and a resistor in series with a voltage source, and the voltage across the resistor is zero, then the capacitor is:

    • Options
    • A. charging
    • B. discharging
    • C. fully charged
    • D. fully discharged
      • Discuss
    • 8. The two most common types of analog-to-digital converters discussed in this chapter were the ______.

    • Options
    • A. linear converter and the analog converter
    • B. linear converter and the successive approximation converter
    • C. flash converter and the analog converter
    • D. flash converter and the successive approximation converter
      • Discuss
    • 9. What is the total power in the circuit?


    • Options
    • A. 170 mW
    • B. 1.7 W
    • C. 17 W
    • D. 170 W
      • Discuss
    • 10. 

      If the output voltage were taken across the resistor in the given circuit, the circuit would be a band-stop filter.


    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.