Discussion
Home ‣ Chemical Engineering ‣ Petroleum Refinery Engineering Comments
- Question
True vapour pressure of a petroleum fraction __________ Reid vapour pressure.
Options- A. is less than
- B. is more than
- C. is same as
- D. may be either more or less than
- Correct Answer
- is more than
- 1. Petroleum liquid fuels having flash point greater than 66°C is considered as safe during storage and handling. Which of the following has flash point > 66°C?
Options- A. Naphtha
- B. Petrol
- C. Kerosene
- D. Heavy fuel oil Discuss
- 2. Crude topping column operates at __________ pressure.
Options- A. atmospheric
- B. 10 atm
- C. vacuum
- D. 3 atm. Discuss
- 3. Increase in the specific gravity of petroleum products indicates
Options- A. decrease in paraffin content.
- B. increase in thermal energy per unit weight.
- C. increase in aromatic content.
- D. higher H/C ratio. Discuss
- 4. The main purpose of recycling the byproduct hydrogen gas in the reformer reactor is to
Options- A. obviate catalyst poisoning.
- B. maintain the reaction temperature.
- C. sustain the reactor pressure.
- D. hydrogenate the feed stock. Discuss
- 5. The general formula of naphthenes is
Options- A. CnH2n + 2
- B. CnH2n-6 (where, n ? 6)
- C. CnHn-4
- D. same as that for olefins i.e. CnH2n Discuss
- 6. Methyl tertiary butyl ether (MTBE), a high octane (octane no. = 115) gasoline blending component is produced by the simple additive reaction of isobutylene with
Options- A. methyl alcohol
- B. ethyl alcohol
- C. methane
- D. ethane Discuss
- 7. Which of the following is the most widely used cracking process in oil refineries?
Options- A. Dubbs process.
- B. T.C.C. moving bed process.
- C. Fluidised bed catalytic cracking process.
- D. Houdry's fixed bed process. Discuss
- 8. Hydrogen percentage (by weight) in crude petroleum may be about
Options- A. 5
- B. 15
- C. 25
- D. 35 Discuss
- 9. The amount of tetraethyl lead added to improve the octane number of motor gasoline is around __________ c.c per gallon of petrol.
Options- A. 3
- B. 300
- C. 3000
- D. 1000 Discuss
- 10. Feedstock for polymerisation is
Options- A. naphtha.
- B. cracked gases rich in C2 & C4 olefins.
- C. low boiling aromatics.
- D. none of these. Discuss
Petroleum Refinery Engineering problems
Search Results
Correct Answer: Heavy fuel oil
Correct Answer: atmospheric
Correct Answer: decrease in paraffin content.
Correct Answer: sustain the reactor pressure.
Correct Answer: same as that for olefins i.e. CnH2n
Correct Answer: methyl alcohol
Correct Answer: Fluidised bed catalytic cracking process.
Correct Answer: 15
Correct Answer: 3
Correct Answer: cracked gases rich in C2 & C4 olefins.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.