Discussion
Home ‣ Chemical Engineering ‣ Petroleum Refinery Engineering Comments
- Question
Which of the following gasolines (unleaded) has the least octane number?
Options- A. Catalytically cracked gasoline
- B. Straight run gasoline
- C. Catalytically reformed gasoline
- D. Polymer gasoline
- Correct Answer
- Straight run gasoline
- 1. Tetraethyl lead is added to the petrol to increase its octane number, because its octane number is
Options- A. more than 100
- B. round about 100
- C. between 50 and 100
- D. less than 25 Discuss
- 2. Higher boiling fractions like atmospheric residue is distilled under vacuum at low temperature because at high temperature, there is a tendency of the predominance of
Options- A. thermal cracking
- B. gum formation
- C. coking
- D. discoloration Discuss
- 3. Which parameter is used for the grading of paraffin waxes?
Options- A. Specific gravity
- B. Melting point
- C. Viscosity
- D. Penetration number Discuss
- 4. Which of the followingis desirable in petrol (gasoline) but undesirable in kerosene?
Options- A. Paraffins
- B. Aromatics
- C. Mercaptans
- D. Naphthenic acid Discuss
- 5. Lane and Garton classification of petroleum is based on its
Options- A. composition
- B. specific gravity
- C. optical properties
- D. viscosity Discuss
- 6. Asphalts are
Options- A. low molecular weight & low boiling point compounds present in petroleum.
- B. desirable in catalytic cracking feedstock, because they produce coke.
- C. readily oxidisable and form carbonaceous sludge.
- D. all (a), (b) & (c). Discuss
- 7. Salt content (measured as sodium chloride) in electrically desalted crude oil comes down to a level of about __________ ptb (pounds per thousand barrel).
Options- A. 0.03
- B. 3
- C. 35
- D. 70 Discuss
- 8. Products drawn from the top to bottom of the crude oil distillation column has progressively increasing
Options- A. boiling points
- B. molecular weight
- C. C/H ratio
- D. all (a), (b) and (c) Discuss
- 9. Char value of Kerosene is the amount of charred oil deposition on the wick obtained after burning it in a standard wick lamp at a standard rate for 24 hours. Char value of a good quality kerosene should be less than __________ mg/kg of kerosene.
Options- A. 1
- B. 20
- C. 100
- D. 500 Discuss
- 10. Which of the following is the most important property for a jet fuel?
Options- A. Cloud point
- B. Pour point
- C. Colour
- D. Freezing point Discuss
Petroleum Refinery Engineering problems
Search Results
Correct Answer: more than 100
Correct Answer: coking
Correct Answer: Viscosity
Correct Answer: Mercaptans
Correct Answer: specific gravity
Correct Answer: readily oxidisable and form carbonaceous sludge.
Correct Answer: 3
Correct Answer: all (a), (b) and (c)
Correct Answer: 20
Correct Answer: Freezing point
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.