Discussion
Home ‣ Chemical Engineering ‣ Polymer Technology Comments
- Question
Pick out the wrong statement.
Options- A. Linear polymers are formed from bifunctional groups only and are normally thermoplastic.
- B. Cross-linked branched chain polymers are either elastometric or thermosetting.
- C. Branching in case of cross-linked polymers caused by small amount of impurities in bifunctional monomer formulation reduces its solubility and increases the softening point.
- D. Dibasic acids reacts with dihydric alcohols to give polyesters using addition polymerisation reaction.
- Correct Answer
- Dibasic acids reacts with dihydric alcohols to give polyesters using addition polymerisation reaction.
- 1. Temperature maintained in the emulsion polymerisation reactor for PVC manufacture is about __________ ° C.
Options- A. -20
- B. 50
- C. 250
- D. 500 Discuss
- 2. Glyptal used in the manufacture of paints & lacquers is a __________ polymer.
Options- A. polyamide
- B. polystyrene
- C. polyester
- D. polyacrylonitrile Discuss
- 3. Condensation polymerisation is not involved in the manufacture of
Options- A. teflon
- B. polythene
- C. terylene
- D. nylon Discuss
- 4. Alkyd resin is a/an
Options- A. polyamide
- B. polyester
- C. polyolefin
- D. addition polymer Discuss
- 5. Polypropylene is preferred to polythene, because the former is
Options- A. non-inflammable
- B. harder
- C. stronger
- D. both(b) & (c) Discuss
- 6. Addition polymerisation is not involved in the manufacture of
Options- A. low density polythene.
- B. poly vinyl chloride.
- C. polystyrene.
- D. polyhexamethylene adipamide. Discuss
- 7. Neoprene is rendered non-inflammable, because of
Options- A. its cross-linked structure.
- B. its linear chain structure.
- C. the presence of chlorine atoms in its monomer.
- D. the absence of chlorine atoms in its monomer. Discuss
- 8. Branched chair polymers as compared to linear polymers have
Options- A. higher melting point.
- B. higher tensile strength.
- C. lower density.
- D. none of these. Discuss
- 9. Flexible foam (for mattresses) are usually made of
Options- A. PVC
- B. silicone rubber
- C. polyurethanes
- D. polyamides Discuss
- 10. Addition of stabiliser during PVC manufacture is done to
Options- A. improve its impact strength.
- B. improve its elasticity.
- C. reduce the melt viscosity & glass transition temperature.
- D. prevent its thermal degradation. Discuss
Polymer Technology problems
Search Results
Correct Answer: 50
Correct Answer: polyester
Correct Answer: polythene
Correct Answer: polyester
Correct Answer: both(b) & (c)
Correct Answer: polyhexamethylene adipamide.
Correct Answer: the presence of chlorine atoms in its monomer.
Correct Answer: lower density.
Correct Answer: polyurethanes
Correct Answer: prevent its thermal degradation.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.