logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Polymer Technology Comments

  • Question
  • Most of the plastics are safe to be used upto a maximum temperature of __________ °C.


  • Options
  • A. 100
  • B. 150
  • C. 350
  • D. 450

  • Correct Answer
  • 150 


  • Polymer Technology problems


    Search Results


    • 1. Most commonly used rubber vulcanisation agent is

    • Options
    • A. sulphur
    • B. bromine
    • C. platinum
    • D. alumina
    • Discuss
    • 2. Which of the following is a natural polyamide fibre.

    • Options
    • A. Wool
    • B. Silk
    • C. Cotton
    • D. None of these
    • Discuss
    • 3. Phenol formaldehyde is produced by condensation polymerisation. It is also known as

    • Options
    • A. teflon
    • B. bakelite
    • C. polyester
    • D. nylon-66
    • Discuss
    • 4. Polycaprolactum is nothing but

    • Options
    • A. orlon
    • B. nylon 6, 6
    • C. nylon 6
    • D. saran
    • Discuss
    • 5. Rayon is superior to cotton in making gauge for wound treatment, because rayon

    • Options
    • A. is a synthetic polymer.
    • B. does not stick to the wound unlike cotton.
    • C. can absorb over 90% of its own weight of water.
    • D. both (b) and (c).
    • Discuss
    • 6. __________ is a thermosetting plastic.

    • Options
    • A. PVC
    • B. Polythene
    • C. Bakelite
    • D. polystyrene
    • Discuss
    • 7. Buna-N is also called

    • Options
    • A. butyl rubber
    • B. nitrile rubber
    • C. neoprene
    • D. thiokol
    • Discuss
    • 8. __________ is a natural fibre.

    • Options
    • A. Cellulose
    • B. Dacron
    • C. Nylon-6
    • D. none of these
    • Discuss
    • 9. Low pressure Zeigler process for the manufacture of polythene uses a catalyst which is

    • Options
    • A. Ni
    • B. V2O5
    • C. Fe
    • D. aluminium triethyl combined with titanium tetrachloride
    • Discuss
    • 10. Phosphates (e.g., triceresyl, tributyl, tetrabutyl, tripheyl etc.) are added to polymers to act as

    • Options
    • A. hardeners
    • B. anti-shrinkage agents
    • C. plasticisers
    • D. transparency improver
    • Discuss


    Comments

    There are no comments.

Enter a new Comment