logo

CuriousTab

CuriousTab

Discussion


Home Chemical Engineering Refractory Technology Comments

  • Question
  • High density refractory bricks have lower


  • Options
  • A. spalling resistance.
  • B. thermal conductivity.
  • C. fusion point.
  • D. slag penetration resistance.

  • Correct Answer
  • spalling resistance. 


  • Refractory Technology problems


    Search Results


    • 1. Tar bonded dolomite bricks

    • Options
    • A. are stored under controlled temperature & humidity to avoid hydration.
    • B. are used in outer lining of L.D. converters.
    • C. have poorer hydration resistance than pitch bonded bricks.
    • D. all (a), (b) and (c)
    • Discuss
    • 2. Maximum safe working temperature for fireclay bricks is about __________ °C.

    • Options
    • A. 1150
    • B. 1300
    • C. 1450
    • D. 1550
    • Discuss
    • 3. Electrical resistor bars are made of

    • Options
    • A. silicon carbide
    • B. alumina
    • C. zirconia
    • D. graphite
    • Discuss
    • 4. Zircon refractories have

    • Options
    • A. low co-efficient of expansion.
    • B. high RUL (1600°C) and refractoriness (> 2000°C).
    • C. high spalling resistance.
    • D. all (a), (b) and (c).
    • Discuss
    • 5. Refractoriness under load (RUL) is the most important property for the refractory bricks

    • Options
    • A. at the hearth bottom of the furnace on which stock is placed.
    • B. used for furnace insulation.
    • C. used in the roof of the furnace.
    • D. none of these.
    • Discuss
    • 6. Periclase refractory contains mainly

    • Options
    • A. CaO
    • B. MgO
    • C. Al2O3
    • D. SiO2
    • Discuss
    • 7. Carbon refractory blocks

    • Options
    • A. are wetted by molten iron.
    • B. are used in the hearth of blast furnace.
    • C. are acidic in nature.
    • D. all (a), (b) and (c).
    • Discuss
    • 8. Fusion point of an acidic refractory material is

    • Options
    • A. increased by the addition of basic oxides.
    • B. reduced by the addition of basic oxides.
    • C. not affected by the addition of basic oxides.
    • D. always more than 2500°C.
    • Discuss
    • 9. Machine moulding of dry mixture of refractories requires a pressure of the order of __________ kg/cm2.

    • Options
    • A. 10
    • B. 100
    • C. 500
    • D. 1000
    • Discuss
    • 10. Cold crushing strength of refractories depends upon its

    • Options
    • A. composition
    • B. texture
    • C. firing temperature
    • D. all (a), (b) and (c)
    • Discuss


    Comments

    There are no comments.

Enter a new Comment