Discussion
Home ‣ Chemical Engineering ‣ Refractory Technology Comments
- Question
Refractoriness under load (RUL) is the most important property for the refractory bricks
Options- A. at the hearth bottom of the furnace on which stock is placed.
- B. used for furnace insulation.
- C. used in the roof of the furnace.
- D. none of these.
- Correct Answer
- at the hearth bottom of the furnace on which stock is placed.
- 1. Si percentage in silica refractories used in the walls of coke oven is about
Options- A. 45
- B. 60
- C. 80
- D. 95 Discuss
- 2. The linear thermal expansion of __________ bricks upto 1000 °C is very low of the order of ? 0.5 percent.
Options- A. fireclay
- B. silica
- C. magnesite
- D. corundum Discuss
- 3. Fireclay bricks are never used in the
Options- A. beehive oven
- B. coke oven walls
- C. zinc roaster
- D. lead blast furnace Discuss
- 4. Silica bricks are attacked by basic slags at high temperature. Which of the following is not used solely as a binding material?
Options- A. aluminium phosphate
- B. water
- C. lime
- D. plaster of paris Discuss
- 5. High thermal conductivity of a refractory material is not important, when it is to be used in the
Options- A. coke oven regenarators
- B. muffle furnace
- C. blast furnace
- D. recuperators Discuss
- 6. Zircon refractories have
Options- A. low co-efficient of expansion.
- B. high RUL (1600°C) and refractoriness (> 2000°C).
- C. high spalling resistance.
- D. all (a), (b) and (c). Discuss
- 7. Electrical resistor bars are made of
Options- A. silicon carbide
- B. alumina
- C. zirconia
- D. graphite Discuss
- 8. Maximum safe working temperature for fireclay bricks is about __________ °C.
Options- A. 1150
- B. 1300
- C. 1450
- D. 1550 Discuss
- 9. Tar bonded dolomite bricks
Options- A. are stored under controlled temperature & humidity to avoid hydration.
- B. are used in outer lining of L.D. converters.
- C. have poorer hydration resistance than pitch bonded bricks.
- D. all (a), (b) and (c) Discuss
- 10. High density refractory bricks have lower
Options- A. spalling resistance.
- B. thermal conductivity.
- C. fusion point.
- D. slag penetration resistance. Discuss
Refractory Technology problems
Search Results
Correct Answer: 95
Correct Answer: fireclay
Correct Answer: coke oven walls
Correct Answer: water
Correct Answer: blast furnace
Correct Answer: all (a), (b) and (c).
Correct Answer: silicon carbide
Correct Answer: 1550
Correct Answer: all (a), (b) and (c)
Correct Answer: spalling resistance.
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.