Discussion
Home ‣ Chemical Engineering ‣ Process Equipment and Plant Design Comments
- Question
Slope of countercurrent flow rotary drier is in the range of __________ meter/metre.
Options- A. 0 to 0.08
- B. 0 to 0.8
- C. 0 to 1.5
- D. 0 to 2.2
- Correct Answer
- 0 to 0.08
- 1. Maximum plate efficiency is achieved in case of __________ flow.
Options- A. split
- B. cross
- C. cascade
- D. reverse Discuss
- 2. Liquid redistribution should be done in a packed tower packed with raschig rings every 6 metres or __________ times the column diameter, whichever is lower.
Options- A. 2.5-3.0
- B. 5-7.5
- C. 10-12.5
- D. 15-20 Discuss
- 3. In a vertical short tube evaporator (Calendria type), the
Options- A. tube dia of 2.5-7.5 cms, tube length of 75-200 cms and cylinderical drum dia of 1-6 metres are normally used.
- B. area of central downtake is equal to 40 to 100% of total cross-sectional area of the surrounding tube.
- C. liquor is inside the tube while the steam is outside the tube.
- D. all (a), (b) & (c). Discuss
- 4. In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a
Options- A. U-bend
- B. floating head tube sheet
- C. either (a) or (b)
- D. neither (a) nor (b) Discuss
- 5. Poisson's ratio of a material is the ratio of unit lateral strain to the unit axial elongation within its elastic limit. The value of Poisson's ratio for structural and pressure vessel steel may be taken as
Options- A. 0.01
- B. 0.3
- C. 0.75
- D. 0.95 Discuss
- 6. __________ tower is the most suitable gas-liquid contacting device involving highly corrosive fluids.
Options- A. Sieve plate
- B. Packed
- C. Bubble cap plate
- D. None of these Discuss
- 7. In case of plain carbon steel, butt welded joints are used for shell plate thickness ? __________ cms.
Options- A. 1.2
- B. 0.5
- C. 3.8
- D. 6.8 Discuss
- 8. Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.
Options- A. 1.25
- B. 1.75
- C. 2.5
- D. 3.5 Discuss
- 9. In distillation columns, bubble caps are held in place over trays by
Options- A. rivets
- B. a hold down bar
- C. bolts
- D. both (b) and (c) Discuss
- 10. The normal range of velocity of water in pipes is __________ m/sec.
Options- A. 0.1-0.5
- B. 1-2
- C. 10-50
- D. 15-30 Discuss
Process Equipment and Plant Design problems
Search Results
Correct Answer: cross
Correct Answer: 2.5-3.0
Correct Answer: all (a), (b) & (c).
Correct Answer: either (a) or (b)
Correct Answer: 0.3
Correct Answer: Packed
Correct Answer: 3.8
Correct Answer: 1.25
Correct Answer: both (b) and (c)
Correct Answer: 1-2
Comments
There are no comments.More in Chemical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.