logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Automation System Comments

  • Question
  • The concept of a general CAD system was that it should provide:


  • Options
  • A. A system for handling user actions.
  • B. A system for the operation of applications programming.
  • C. A set of basic system functions and utilities.
  • D. All of the above
  • E. None of the above

  • Correct Answer
  • All of the above 


  • Automation System problems


    Search Results


    • 1. The integrated circuit:

    • Options
    • A. often is called a "chip"
    • B. led to the development of the transistor
    • C. has revolutionized electronics
    • D. (b) and (c)
    • E. None of the above
    • Discuss
    • 2. The accuracy of a pick-and-place robot can be as good as:

    • Options
    • A. + 0.0005 inches
    • B. + 0.05 inches
    • C. 0.008 inches
    • D. + 3%
    • E. None of the above
    • Discuss
    • 3. Operator interaction directly with the CRT is accomplished via:

    • Options
    • A. a digitizing tablet
    • B. vector scanning
    • C. a stylus
    • D. a touch terminal
    • E. None of the above
    • Discuss
    • 4. Localizing an object in an image and selectively analyzing the object in a series of redundant layers is referred to as the:

    • Options
    • A. Turing test
    • B. pyramid
    • C. Gaussian pyramid
    • D. Maxwell pyramid
    • E. None of the above
    • Discuss
    • 5. Most data transmission in the future will be:

    • Options
    • A. digital bit stream encoded data
    • B. analog in nature
    • C. carried over metallic telephone lines
    • D. All of the above
    • E. None of the above
    • Discuss
    • 6. The "walk-through" method of programming a robot involves:

    • Options
    • A. walking through your suggested procedure with your supervisor prior to programming
    • B. physically moving the robot through all the motions it is to repeat
    • C. moving the robot from one location to another
    • D. All of the above.
    • E. None of the above
    • Discuss
    • 7. What is offset error?

    • Options
    • A. the difference between the sensor input and the absolute sensed parameter.
    • B. the difference between the controller output and the setting of the manipulated variable.
    • C. the difference between the control setpoint value and the actual value.
    • D. All of the above
    • E. None of the above
    • Discuss
    • 8. Ergonomics refers to:

    • Options
    • A. the human aspect of the environment around the workstation as well as the workstation itself
    • B. the cost relationship of the workstation versus productivity
    • C. the level of involvement the operator has with the workstation
    • D. the technology involved in the workstation itself
    • E. None of the above
    • Discuss
    • 9. Which of the following is a graphical output device?

    • Options
    • A. Dot-matrix Printer
    • B. Plotter
    • C. Laser Printer
    • D. Line Printer
    • E. None of the above
    • Discuss
    • 10. In the operation of a programmable controller:

    • Options
    • A. all of the logic status is maintained in memory
    • B. any latched data must be done using an external latching relay
    • C. mathematics cannot be performed
    • D. All of the above
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment