logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Automation System Comments

  • Question
  • A programmable controller:


  • Options
  • A. can be used on more than one machine during its lifetime.
  • B. can be reprogrammed in the field
  • C. requires considerable training before it can be used
  • D. (a) and (b) above
  • E. None of the above

  • Correct Answer
  • (a) and (b) above 


  • Automation System problems


    Search Results


    • 1. An intelligent robot can:

    • Options
    • A. make decisions
    • B. handle only small payloads
    • C. walk
    • D. speak
    • E. None of the above
    • Discuss
    • 2. Robots can increase productivity because:

    • Options
    • A. they do not take a vacation
    • B. they do not get tired
    • C. production quality is uniform
    • D. All of the above
    • E. None of the above
    • Discuss
    • 3. Which of the following method is used the results of a design analysis as a base for redesign decisions?

    • Options
    • A. The iterative design method
    • B. The direct method
    • C. The design selection method
    • D. All of the above
    • E. None of the above
    • Discuss
    • 4. A favourable reason for automation is to:

    • Options
    • A. decrease throughput
    • B. raises assembly cost
    • C. perform difficult operations
    • D. increase number of operations
    • E. None of the above
    • Discuss
    • 5. What is proportional control?

    • Options
    • A. It has a discrete output for each error value
    • B. The controller output varies continuously over a range
    • C. The gain is independent of offset error.
    • D. All of the above
    • E. None of the above
    • Discuss
    • 6. A Hall effect switch is usually used to:

    • Options
    • A. , measure voltage
    • B. measure temperature
    • C. sense a vacuum
    • D. sense the presence of a magnetic object.
    • E. None of the above
    • Discuss
    • 7. The hardware device Jhat acts as both a switching and connecting unit is called a(n):

    • Options
    • A. concentrator
    • B. RS-232C port
    • C. multiplexer
    • D. communications processor
    • E. None of the above
    • Discuss
    • 8. Most continuous control actuators:

    • Options
    • A. are of the time proportioning type
    • B. use a 4 to 20 mA current loop input
    • C. are used with standard continuous control loop
    • D. (b) and (c) above
    • E. None of the above
    • Discuss
    • 9. What kind of capability is required if one plans to interface with a plotter or printer?

    • Options
    • A. A graphics cable
    • B. RGB monitor
    • C. A graphics board
    • D. A co-processor
    • E. None of the above
    • Discuss
    • 10. The digitizing technology that uses an electric field radiated from the tablet and picked up by a cursor is:

    • Options
    • A. electromagnetic
    • B. raster
    • C. sonic
    • D. electrostic
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment