logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Networking Comments

  • Question
  • After coding a document into a digital signal, it can be sent by telephone, telex or satellite to the receiver where the signal is decoded and an exact copy of the original document is made. What is it called?


  • Options
  • A. Telex
  • B. Word processor
  • C. Facsimile
  • D. Electronic mail
  • E. None of the above

  • Correct Answer
  • Facsimile 


  • Networking problems


    Search Results


    • 1. Typewriter terminals can print computer-generated data at a rate of

    • Options
    • A. 10 characters per second
    • B. 120 characters per second
    • C. 120 characters per minute
    • D. 1200 characters per minute
    • E. None of the above
    • Discuss
    • 2. The area of coverage of a satellite radio beam is known as

    • Options
    • A. Footprint
    • B. Circular polarization
    • C. Beam width
    • D. Identity
    • E. None of the above
    • Discuss
    • 3. What is the name of the device that connects two computers by means of a telephone line?

    • Options
    • A. Tape
    • B. modem
    • C. bus
    • D. cable
    • E. None of the above
    • Discuss
    • 4. An error detecting code is which code is the remainder resulting from dividing the bits to be checked by a predetermined binary number, is known as

    • Options
    • A. Cyclic redundancy check
    • B. Checksum
    • C. Error detecting code
    • D. Error rate
    • E. None of the above
    • Discuss
    • 5. In OSI network architecture, the routing is performed by

    • Options
    • A. network layer
    • B. data link layer
    • C. transport layer
    • D. session layer
    • E. None of the above
    • Discuss
    • 6. RS-232-G

    • Options
    • A. is an interface between two data circuit terminating equipment as examplified by a local and remote modem
    • B. is an interface standard between Data terminal Equipment and Data Circuit Terminating Equipment
    • C. specifies only the mechanical characteristics of an interface by providing a 25-pin connector
    • D. requires only 7 pin out of 25 in order to transmit digital data over public telephone lines
    • E. None of the above
    • Discuss
    • 7. In a _____ topology, if there are n devices in a network, each device has n - 1 ports for cables.

    • Options
    • A. ring
    • B. bus
    • C. star
    • D. mesh
    • E. None of the above
    • Discuss
    • 8. The _____ layer is the layer closest to the transmission medium.

    • Options
    • A. transport
    • B. network
    • C. data link
    • D. physical
    • E. None of the above
    • Discuss
    • 9. A distributed data processing configuration in which all activities must pass through a centrally located computer is called a:

    • Options
    • A. ring network
    • B. spider network
    • C. hierarchical network
    • D. data control network
    • E. None of the above
    • Discuss
    • 10. What is the main difference between DDCMP and SDLG?

    • Options
    • A. DDCMP does not need special hardware to final the beginning of a message.
    • B. DDCMP has a message header
    • C. SDLC has a IP address
    • D. SDLC does not use CRC
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment