Discussion
Home ‣ Computer Science ‣ Computer Hardware Comments
- Question
Resistance is measured:
Options- A. in parallel
- B. in series
- C. after breaking the circuit
- D. after checking voltage
- E. after checking current
- Correct Answer
- after breaking the circuit
- 1. What command is used to hand up a MODEM when using the "AT Answer Command set"?
Options- A. ATZ
- B. ATD
- C. ATR
- D. ATH
- E. None of the above Discuss
- 2. The 34-pin connection on an I/O card is for?
Options- A. floppy drive
- B. SCSI drive
- C. IDE drive
- D. zip drive
- E. None of the above Discuss
- 3. Why does a successfully mapped network drive disappear every time you boot the computer?
Options- A. The computer you are connected to has moved
- B. You didn't click reconnect on log on
- C. The map statement is not in the autoexec.bat file
- D. The last drive was not set correctly
- E. None of the above Discuss
- 4. When you boot a PC and don't hear any beep, this could suggest which of the following?
Options- A. The monitor is turned off
- B. Keyboard not plugged in
- C. Normal PC boot
- D. Bad or disconnected speaker
- E. None of the above Discuss
- 5. You have a 15 pin female connector with the pins in two rows. What could you connect with this?
Options- A. Serial device
- B. Parallel device
- C. MIDI device
- D. Video device
- E. Joystick Discuss
- 6. During boot-up, the memory test:
Options- A. Is a superfluous step that should be ignored
- B. Checks and verifies that contiguous memory is installed
- C. Is an operational error
- D. Displays what memory is installed, but nothing else
- E. None of the above Discuss
- 7. You run a super wing-ding diagnostic program on your PC, and it reports that your hard drive, microprocessor, RAM, and video card have seen better days. To resolve this problem you should:
Options- A. replace each part one at a time, rerunning the diagnostic before replacing the next part.
- B. check to see if you have a software problem
- C. replace everything at once and rerun the diagnostic
- D. get another copy of the diagnostic program
- E. run an exhaustive memory check Discuss
- 8. After you service a laser printer, you notice dirty print. Which of the following would correct the problem.
Options- A. Clean the developer tank
- B. Reset the printer
- C. Run several blank pages
- D. Clean the laser diode
- E. None of the above Discuss
- 9. An anti static strap uses a small _____ to make sure you do not become the least path of resistance to the ground?
Options- A. capacitor
- B. diode
- C. transistor
- D. resistor
- E. None of the above Discuss
- 10. Which best describes a fragmented hard drive:
Options- A. The platters are bad
- B. Data files are corrupted
- C. Clusters of data are damaged
- D. Files are not stored in consecutive clusters
- E. None of the above Discuss
Computer Hardware problems
Search Results
Correct Answer: ATH
Correct Answer: floppy drive
Correct Answer: The map statement is not in the autoexec.bat file
Correct Answer: Bad or disconnected speaker
Correct Answer: Joystick
Correct Answer: Is a superfluous step that should be ignored
Correct Answer: check to see if you have a software problem
Correct Answer: Run several blank pages
Correct Answer: resistor
Correct Answer: Files are not stored in consecutive clusters
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.