logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Computer Hardware Comments

  • Question
  • What is the most likely cause of an "FDD controller Failure" error message?


  • Options
  • A. you did not set the jumper on the floppy drive to drive A
  • B. you forgot to flash CMOS
  • C. you installed the floppy disk drive cable backward
  • D. your computer's floppy drive is defective
  • E. None of the above

  • Correct Answer
  • you installed the floppy disk drive cable backward 


  • Computer Hardware problems


    Search Results


    • 1. WRAM is used on a

    • Options
    • A. modem
    • B. video card
    • C. motherboard
    • D. ata connector
    • E. None of the above
    • Discuss
    • 2. On a leased line installation a known good external modem shows no carrier detect light. Where is the problem most likely to be?

    • Options
    • A. In the modem
    • B. In the phone line
    • C. In the computer
    • D. In the DTC equipment
    • E. None of the above
    • Discuss
    • 3. After you service a laser printer, you notice dirty print. Which of the following would correct the problem?

    • Options
    • A. Clean the developer tank
    • B. Reset the printer
    • C. Run several blank pages
    • D. Clean the laser diode
    • E. None of the above
    • Discuss
    • 4. Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.

    • Options
    • A. bad data cable
    • B. incorrect jumper setting on drive
    • C. loose molex connector
    • D. virus
    • E. tfad system board
    • Discuss
    • 5. A PCMCIA measuring 10.5mm is what type?

    • Options
    • A. type 1
    • B. type 2
    • C. type 1 and 3
    • D. type 3
    • E. None of the above
    • Discuss
    • 6. When you are testing a fuse, you should set the Volt-OHM meter to what scale?

    • Options
    • A. AC
    • B. DC
    • C. AMPS
    • D. OHMS
    • E. None of the above
    • Discuss
    • 7. You have a 15 pin female connector with the pins in two rows. What could you connect with this?

    • Options
    • A. Serial device
    • B. Parallel device
    • C. MIDI device
    • D. Video device
    • E. Joystick
    • Discuss
    • 8. When you boot a PC and don't hear any beep, this could suggest which of the following?

    • Options
    • A. The monitor is turned off
    • B. Keyboard not plugged in
    • C. Normal PC boot
    • D. Bad or disconnected speaker
    • E. None of the above
    • Discuss
    • 9. Why does a successfully mapped network drive disappear every time you boot the computer?

    • Options
    • A. The computer you are connected to has moved
    • B. You didn't click reconnect on log on
    • C. The map statement is not in the autoexec.bat file
    • D. The last drive was not set correctly
    • E. None of the above
    • Discuss
    • 10. The 34-pin connection on an I/O card is for?

    • Options
    • A. floppy drive
    • B. SCSI drive
    • C. IDE drive
    • D. zip drive
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment