logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Computer Hardware Comments

  • Question
  • What is the jumper setting on a SCSI device to configure it to use the fourth SCSI id? Remember, SCSI ids start with zero.


  • Options
  • A. 010
  • B. 110
  • C. 011
  • D. 101
  • E. 001

  • Correct Answer
  • 011 


  • Computer Hardware problems


    Search Results


    • 1. When configuring a new network interface card for installation, which of the following would be a valid I/O address?

    • Options
    • A. 378
    • B. 2F8
    • C. 3F8
    • D. 360
    • E. None of the above
    • Discuss
    • 2. If a computer's BIOS allows it, you can boot from a CD-ROM.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. ESD damage can be caused by:

    • Options
    • A. Placing an IC in a non-conductive plastic bag
    • B. Placing an IC on a grounded mat
    • C. Repeated sags in current supplied from outlets
    • D. Touching metal on the chasis
    • E. None of the above
    • Discuss
    • 4. Which provides the fastest data access time?

    • Options
    • A. RAM
    • B. ROM
    • C. CD-ROM
    • D. Hard disk
    • E. None of the above
    • Discuss
    • 5. Which best describes a fragmented hard drive:

    • Options
    • A. The platters are bad
    • B. Data files are corrupted
    • C. Clusters of data are damaged
    • D. Files are not stored in consecutive clusters
    • E. None of the above
    • Discuss
    • 6. What problem can occur if a printer cable is to close to a power cable?

    • Options
    • A. ESD Electrostatic Discharge
    • B. EMI Electromagnetic Interference
    • C. parity error
    • D. no affect
    • E. None of the above
    • Discuss
    • 7. You are testing the resistance in Ohms of a fuse on a 5 amp system. If the fuse is good, the meter should read?

    • Options
    • A. 5.0
    • B. 0.5
    • C. 0.0
    • D. All of the above
    • E. None of the above
    • Discuss
    • 8. The acronym HDI stands for:

    • Options
    • A. Half duplex interface
    • B. Hard disk interface
    • C. Head to disk interference
    • D. Help desk interference
    • E. None of the above
    • Discuss
    • 9. COM 4 uses which I/O port?

    • Options
    • A. 2F8H
    • B. 3F8H
    • C. 3E8H
    • D. 2E8H
    • E. None of the above
    • Discuss
    • 10. What problem can occur if a printer cable is to close to a power cable?

    • Options
    • A. ESD Electrostatic Discharge
    • B. EMI Electromagnetic Interference
    • C. parity error
    • D. no affect
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment