Discussion
Home ‣ Computer Science ‣ Computer Hardware Comments
- Question
What is the modem hang up command?
Options- A. ATHU
- B. ATH
- C. ATZ
- D. ATX
- E. None of the above
- Correct Answer
- ATH
- 1. You see the message "invalid media device" after installing a new hard drive. What do you do next?
Options- A. Format
- B. Fdisk
- C. Partition
- D. Add the OS
- E. None of the above Discuss
- 2. A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
Options- A. C
- B. D
- C. E
- D. F
- E. None of the above Discuss
- 3. "Parity" errors usually indicate bad memory.
Options- A. True
- B. False Discuss
- 4. An IRQ allow interface cards to:
Options- A. Interrupt the CPU to request service
- B. Pass data to the CPU to be processed
- C. Pass data from one card to another
- D. Pass data to the computers memory
- E. None of the above Discuss
- 5. Resistance is measured in ohm.
Options- A. True
- B. False Discuss
- 6. COM1 is typically represented by which of the following?
Options- A. 15 pin port
- B. 9 pin male port
- C. 9 pin female port
- D. 25 pin male port
- E. None of the above Discuss
- 7. One of the major components of a PC is the Central Processing Unit (CPU) which can be best described as:
Options- A. The device that sends the monitor signals telling it what to display
- B. The area that regulates all of the system power usage
- C. The area where ail the of the Basic input/output routines are stored
- D. The area where all of the processing takes place
- E. None of the above Discuss
- 8. A dialog box with a bomb appears on a Macintosh screen. What type of problem has occurred?
Options- A. A RAM problem
- B. A software problem
- C. A ROM problem
- D. An ADB problem
- E. None of the above Discuss
- 9. In the Binary numbering system, a (1) represents a jumper being shorted and a (0) represents a jumper being open. On a three-bit jumper block on a SCSI drive, how would an ID of logical 3 be set?
Options- A. 100
- B. 010
- C. 011
- D. . 101
- E. None of the above Discuss
- 10. During preventative maintenance on a dot matrix printer, do NOT lubricate:
Options- A. Platen assembly
- B. Print head pulley
- C. Print head pins
- D. Paper advance gear bushings
- E. None of the above Discuss
Computer Hardware problems
Search Results
Correct Answer: Format
Correct Answer: D
Correct Answer: True
Correct Answer: Interrupt the CPU to request service
Correct Answer: True
Correct Answer: 9 pin male port
Correct Answer: The area where all of the processing takes place
Correct Answer: A software problem
Correct Answer: 011
Correct Answer: Print head pins
Comments
There are no comments.More in Computer Science:
Programming
Copyright ©CuriousTab. All rights reserved.