logo

CuriousTab

CuriousTab

Discussion


Home Computer Science Computer Hardware Comments

  • Question
  • Modems use transmission.


  • Options
  • A. synchronous
  • B. asynchronous
  • C. timed interval
  • D. ata
  • E. bank

  • Correct Answer
  • asynchronous 


  • Computer Hardware problems


    Search Results


    • 1. After installing a sound card, the system locks up when a parallel port tape backup unit is also used. What is most likely the problem?

    • Options
    • A. IRQ
    • B. DMA
    • C. defective LPT port
    • D. defective tape driver
    • E. defective sound card.
    • Discuss
    • 2. You are testing the resistance in Ohms of a fuse on a 15K amp system. If the fuse is good, the meter should read?

    • Options
    • A. 0.0
    • B. 0.2
    • C. 5.0
    • D. 2.0
    • E. None of the above
    • Discuss
    • 3. What expansion types do most pll/plll motherboards support?

    • Options
    • A. MCA, PCI
    • B. ISA, EISA
    • C. ISA, PCI, AGP
    • D. ISA, VESA, PCI
    • E. None of the above
    • Discuss
    • 4. A capacitor is measured in which of the following units?

    • Options
    • A. Volts
    • B. Ohms
    • C. Farads
    • D. Resistance
    • E. None of the above
    • Discuss
    • 5. Capacitance is measured in units of:

    • Options
    • A. volts
    • B. amps
    • C. farads
    • D. neutrinos
    • E. anti-neutrinos
    • Discuss
    • 6. A 25-pin female connector on the back of your computer will typically be:

    • Options
    • A. Serial port 1
    • B. A parallel port
    • C. Docking
    • D. COM2 port
    • E. None of the above
    • Discuss
    • 7. When installing an internal modem, all of the following IRQ's can be used except?

    • Options
    • A. 5
    • B. 10
    • C. 14
    • D. All of the above
    • E. None of the above
    • Discuss
    • 8. A hard disk is divided into tracks which are further subdivided into:

    • Options
    • A. clusters
    • B. sectors
    • C. vectors
    • D. heads
    • E. None of the above
    • Discuss
    • 9. The DC voltage on most circuit boards is:

    • Options
    • A. -12 volts
    • B. 0 volts
    • C. +5 volts
    • D. +12 volts
    • E. None of the above
    • Discuss
    • 10. What would you ask to determine if the display is working?

    • Options
    • A. Is there a video cursor or action on the screen?
    • B. Did the computer beep or chime?
    • C. Is there high voltage static on the screen
    • D. All of the above
    • E. None of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment