CuriousTab

CuriousTab

Home Aptitude

Discussion

Home ‣ Electronics and Communication Engineering ‣ Matching Questions Comments

Question

Match the following:

List I (Location of characteristics roots) List II (System characteristic)

A. (- 1 + j), (- 1 - j) 1. Marginally stable

B. (- 2 + j), (- 2 - j), (2, j) (- 2, j) 2. Unstable

C. - j, j - 1, 1 3. Stable

Options
A. A-1, B-2, C-3
B. A-2, B-3, C-1
C. A-3, B-1, C-2
D. A-1, B-3, C-2

Correct Answer

A-3, B-1, C-2

Matching Questions problems

Search Results

1. Match the following:

	List I		List II
A.	? x = 0	1.	irrotational vector
B.	? . = 0	2.	conservative field
C.	? .dl = 0	3.	solenoidal vector

Options
A. A-3, B-1, C-2
B. A-1, B-2, C-3
C. A-2, B-3, C-1
D. A-3, B-2, C-1

2. Match the following:

	List I		List II
A.	Sky wave	1.	parasitic elements
B.	Antenna feed	2.	delta match
C.	Reflector	3.	long-wire antenna
D.	Rhombic antenna	4.	ionosphere

Options
A. A-1, B-3, C-4, D-2
B. A-2, B-1, C-3, D-4
C. A-1, B-2, C-3, D-4
D. A-4, B-2, C-1, D-3

3. Match the following:

	List I		List II
A.	SUS	1.
B.	SBS	2.
C.	SCS	3.
D.	Shockley diode	4.

Options
A. A-1, B-2, C-3, D-4
B. A-1, B-3, C-4, D-2
C. A-4, B-2, C-3, D-1
D. A-1, B-2, C-4, D-3

4. Match the following:

	List I (Amplifier coupling)		List II (Feature)
A.	RC	1.	High voltage gain and impedance matching
B.	Inductive	2.	Ability to amplify dc and low frequency signals
C.	Transformer	3.	Minimum non-linear distortion
D.	Direct	4.	Low collector supply voltage can be used

Options
A. A-4, B-1, C-3, D-2
B. A-3, B-4, C-1, D-2
C. A-1, B-2, C-3, D-4
D. A-4, B-3, C-2, D-1

5. Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

Options
A. A-4, B-3, C-1, D-2
B. A-3, B-2, C-1, D-4
C. A-4, B-3, C-2, D-1
D. A-3, B-2, C-4, D-1

6. Match the following:

	List I		List II
A.	Digital counter	1.	Measurement of harmonics
B.	Schering Bridge	2.	Measurement of frequency
C.	Meggar	3.	Measurement of loss angle of dielectric
D.	Spectrum analyser	4.	Measurement of insulation resistance

Options
A. A-1, B-2, C-3, D-4
B. A-4, B-3, C-2, D-1
C. A-2, B-3, C-4, D-1
D. A-4, B-1, C-3, D-2

7. Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Bitwise inclusive OR
B.	&	2.	Bitwise AND
C.	\| \|	3.	Logical AND
D.	\|	4.	Logical OR

Options
A. A-1, B-2, C-3, D-4
B. A-3, B-2, C-4, D-1
C. A-2, B-3, C-1, D-4
D. A-1, B-4, C-2, D-3

8. Match the following:

	List I		List II
A.	Fourier transform of a Gaussian function	1.	Gaussian function
B.	Convolution of a rectangular pulse with itself	2.	Rectangular pulse
C.	Current through inductor for step input voltage	3.	Triangular pulse
		4.	Ramp function
		5.	Zero

Options
A. A-1, B-2, C-3
B. A-2, B-4, C-5
C. A-1, B-3, C-4
D. A-2, B-3, C-5

9. Match the following:

	List I		List II
A.	Continuous and aperiodic	1.	Fourier representation is continuous and aperiodic
B.	Continuous and Periodic	2.	Fourier representation is discrete and aperiodic
C.	Discrete and aperiodic	3.	Fourier representation is continuous and periodic
D.	Discrete and periodic	4.	Fourier representation is discrete and periodic

Options
A. A-3, B-2, C-4, D-1
B. A-1, B-3, C-2, D-4
C. A-1, B-2, C-3, D-4
D. A-2, B-1, C-4, D-3

10. Match the following:

	List I (BHE, A0)		List II (Word is read/write)
A.	0, 0	1.	1 byte from/to odd address
B.	0, 1	2.	1 byte from/to even address
C.	1, 0	3.	16 bit word
D.	1, 1	4.	None

Options
A. A-1, B-2, C-3, D-4
B. A-3, B-1, C-2, D-4
C. A-2, B-3, C-4, D-1
D. A-4, B-1, C-2, D-3

Comments

More in Electronics and Communication Engineering: