logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Microwave Communication Comments

  • Question
  • For a rectangular waveguide having width a and height b, the cutoff wavelength for TM11 mode is equal to


  • Options
  • A. For a rectangular waveguide having width a and height b, the cutoff wavelength for TM11 mode is equa
  • B. For a rectangular waveguide having width a and height b, the cutoff wavelength for TM11 mode is equa
  • C. For a rectangular waveguide having width a and height b, the cutoff wavelength for TM11 mode is equa
  • D. For a rectangular waveguide having width a and height b, the cutoff wavelength for TM11 mode is equa

  • Correct Answer
  •  


  • Microwave Communication problems


    Search Results


    • 1. A circular polarizer converts a linearly polarized wave into a circularly polarised wave.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. In a circular waveguide with radius r, the dominant mode is

    • Options
    • A. TM01
    • B. TE01
    • C. TM11
    • D. TE11
    • Discuss
    • 3. Consider the following time parameters

      1. Domain growth time constant.
      2. Transit time.
      3. Dielectric relaxation time in positive mobility regime.
      Which of the above are used in connection width transferred electron device?

    • Options
    • A. 1, 2, and 3
    • B. 1 and 2 only
    • C. 1 and 3 only
    • D. 2 and 3 only
    • Discuss
    • 4. A disadvantage of microstrip line as the connections of compared to strip line is that former

    • Options
    • A. do not lend themselves to printed circuit
    • B. are more likely to radiate
    • C. are bulky
    • D. are more expensive and complex
    • Discuss
    • 5. A radar has a maximum range of 120 km. The maximum allowable pulse repetition frequency for unambiguous reception is

    • Options
    • A. 1250
    • B. 330
    • C. 2500
    • D. 8330
    • Discuss
    • 6. A circular waveguide carries TE11 mode whole radial electric field is given by
      Er = E0j1(r) sin ? V/m
      where r is radial distance in cm from the axis
      The cut off wavelength is

    • Options
    • A. 10 cm
    • B. 3 p cm
    • C. 2 p cm
    • D. 8 cm
    • Discuss
    • 7. A 75 ohm line is first short terminated and minima locations are noted. Then the short is replaced by resistive load and minima location are again noted. If minima location are not altered and VSWR is 3, the value of resistive load is

    • Options
    • A. 25 ?
    • B. 50 ?
    • C. 225 ?
    • D. 250 ?
    • Discuss
    • 8. As frequency increases, the transmission efficiency

    • Options
    • A. decreases
    • B. increases
    • C. is not affected
    • D. either (a) or (c)
    • Discuss
    • 9. A parametric amplifier uses

    • Options
    • A. non linear resistance
    • B. non linear reactance
    • C. either (a) or (b)
    • D. neither (a) nor (b)
    • Discuss
    • 10. Effect of loading of line is

    • Options
    • A. increase in Z0, a and ?
    • B. increase in Z0 and ? but decrease in a
    • C. decrease in Z0, a and ?
    • D. decrease in Z0 and ? but increase in a
    • Discuss


    Comments

    There are no comments.

Enter a new Comment