logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Power Electronics Comments

  • Question
  • In thermal ohm's law, temperature and power loss are analogous to


  • Options
  • A. V and I respectively of ohm's law
  • B. I and V respectively of ohm's law
  • C. R and V respectively of ohm's law
  • D. I and R respectively of ohm's law

  • Correct Answer
  • I and V respectively of ohm's law 


  • Power Electronics problems


    Search Results


    • 1. In a single phase full wave converter (M-2 connection) feeding on R-L load the input voltage is v = Vm sin ?t. The expression for rms output voltage is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 2. When a power diode is conducting, the voltage drop across it is about

    • Options
    • A. I V
    • B. 5 V
    • C. 20 V
    • D. 50 V
    • Discuss
    • 3. In a parallel inverter

    • Options
    • A. each thyristor is turned on twice during each cycle
    • B. each thyristor is turned on once during each cycle
    • C. each thyristor is turned on either once or twice in each load cycle
    • D. each thyristor may be turned on upto four times in each load cycle
    • Discuss
    • 4. The minimum gate current which can turn on SCR is called :

    • Options
    • A. trigger current
    • B. holding current
    • C. junction current
    • D. breakover current
    • Discuss
    • 5. The output frequency of a cycloconverter can be changed by changing the firing angle.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. The symbol in figure is for

    • Options
    • A. SUS
    • B. SBS
    • C. Shockley diode
    • D. UJT
    • Discuss
    • 7. In a 3 phase full converter, the instantaneous output voltage can have negative part if

    • Options
    • A. firing angle is less than 60°
    • B. firing angle is less than 90°
    • C. firing angle is more than 60°
    • D. firing angle is more than 90°
    • Discuss
    • 8. Which inverter circuit uses coupled inductors?

    • Options
    • A. Modified McMurray full bridge inverter
    • B. McMurray Bedford half bridge inverter
    • C. Modified McMurray Bedford half bridge inverter
    • D. Both (b) and (c)
    • Discuss
    • 9. In a series inverter

    • Options
    • A. the commutating elements L and C are in parallel
    • B. the commutating elements L and C are in series with load
    • C. the commutating L and C may be in series or parallel with the load
    • D. none of the above
    • Discuss
    • 10. If the frequency is less than the damped frequency in a series- inverter

    • Options
    • A. the distortion of output voltage waveform is low
    • B. the distortion of output voltage waveform is high
    • C. the distortion of output voltage may be high or low depending on the load impedance
    • D. none of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment