logo

CuriousTab

CuriousTab

Discussion


Home Electronics and Communication Engineering Satellite Communication See What Others Are Saying!
  • Question
  • The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.


  • Options
  • A. 540
  • B. 270
  • C. 135
  • D. 1080

  • Correct Answer
  • 270 


  • More questions

    • 1. In figure what is the base current if VBE = 0.7 V

    • Options
    • A. 10 mA
    • B. 9.3 mA
    • C. 10 ?A
    • D. 9.3 ?A
    • Discuss
    • 2. EEPROM permits

    • Options
    • A. read operation only
    • B. read and byte erase operations
    • C. read, byte erase and byte write operations
    • D. read, byte erase, byte write and chip erase operations
    • Discuss
    • 3. The typical squelch circuit

    • Options
    • A. cuts off an IF amplifier when the AGC is maximum
    • B. cuts off an IF amplifier when the AGC is minimum
    • C. cuts off an audio amplifier when the carrier is absent
    • D. eliminates the RF interference when the signal is weak
    • Discuss
    • 4. If we connect two silicon unilateral switches in anti- parallel we get

    • Options
    • A. SCR
    • B. SBS
    • C. SCS
    • D. UJT
    • Discuss
    • 5. In a fascimile reproduction time to scan one line is 2 ms. If it has 4% blanking, the visible trace time is

    • Options
    • A. 1.92 ms
    • B. 2.08 ms
    • C. 50 ms
    • D. 0.08 ms
    • Discuss
    • 6. If a step down chopper is fed by a dc voltage V with Ton and Toff are on and off periods then is

    • Options
    • A. average output voltage
    • B. rms output voltage
    • C. average or rms output voltage depending on load
    • D. neither of the above
    • Discuss
    • 7. A single phase cycloconverter feeds a resistance heating load. The heating power is provided by

    • Options
    • A. only the fundamental component of output wave
    • B. only higher harmonics in the output wave
    • C. both fundamental and higher harmonics in the output wave
    • D. either (a) or (b)
    • Discuss
    • 8. Which of these has lowest dielectric strength?

    • Options
    • A. Dry air
    • B. Wet air
    • C. Cotton
    • D. Paper
    • Discuss
    • 9. The number of noise sources in a BJT are

    • Options
    • A. 3
    • B. 2
    • C. 1
    • D. 4
    • Discuss
    • 10. For a base current of 10 ?A, what is the value of collector current in common emitter if ?dc = 100

    • Options
    • A. 10 ?A
    • B. 100 ?A
    • C. 1 mA
    • D. 10 mA
    • Discuss


    Comments

    There are no comments.

Enter a new Comment