logo

CuriousTab

CuriousTab

Discussion

Home ‣ Civil Engineering ‣ GATE Exam Questions Comments
  • Question

  • A steel beam supporting loads from the floor slab as well as from wall is termed as


  • Options
  • A. Stringer beam
  • B. Lintel beam
  • C. Spandrel beam
  • D. Header beam

  • Correct Answer
  • Stringer beam 

    • GATE Exam Questions problems

    Search Results

    • 1. A weir on a permeable foundation with downstream sheet pile is shown in the figure below. The exit gradient as per Khosla's method is

    • Options
    • A. 1 in 6.0
    • B. 1 in 5.0
    • C. 1 in 3.4
    • D. 1 in 2.5
      • Discuss
    • 2. The lateral ties in a reinforced concrete rectangular column uncle: axial compression are used to :

    • Options
    • A. avoid the buckling of the longitudinal steel under compression
    • B. provide adequate shear capacity
    • C. provide adequate confinement to concrete
    • D. reduce the axial deformation of the column
      • Discuss
    • 3. The degree of kinematic indeterminacy of the rigid frame with clamped ends at A and D shown in the below figure is,

    • Options
    • A. 4
    • B. 3
    • C. 2
    • D. zero
      • Discuss
    • 4. If soil is dried beyond its shrinkage limit, it will show :

    • Options
    • A. Large volume change
    • B. Moderate volume change
    • C. Low volume change
    • D. No volume change
      • Discuss
    • 5. The specific gravity of paving bitumen as per IS:73-1992 lies between

    • Options
    • A. 1.10 and 1.06
    • B. 1.06 and 1.02
    • C. 1.02 and 0.97
    • D. 0.97 and 0.92
      • Discuss
    • 6. Which one of the following set of values give the minimum clear cover (in mm) for the main reinforcements in the slab, beam, column and footing, respectively, according to IS : 456-1978?

    • Options
    • A. 20, 25, 30, 75
    • B. 5, 15, 25, 50
    • C. 15, 25, 40, 75
    • D. none of the above
      • Discuss
    • 7. The centre of pressure of a liquid on a plane surface immersed vertically in a static body of liquid, always lies below the centroid of the surface area, because

    • Options
    • A. in liquids the pressure acting is same in-all directions
    • B. there is no shear stress in liquids at rest
    • C. the liquid pressure is constant over depth
    • D. the liquid pressure increases linearly with depth
      • Discuss
    • 8. A propped cantilever beam of span L, is loaded with uniformly distributed load of intensity w/unit length, all through the span. Bending moment at the fixed end is,

    • Options
    • A.
    • B.
    • C.
    • D.
      • Discuss
    • 9. The liquid limit (LL), plastic limit (PL) and shrinkage limit (SL) of a cohesive soil satisfy the relation

    • Options
    • A. LL > PL < SL
    • B. LL > PL > SL
    • C. LL < PL < SL
    • D. LL < PL > SL
      • Discuss
    • 10. The plan of a survey plotted to a scale of 10 m to 1 cm is reduced in such a way that a line originally 10 cm long now measures 9 cm. The area of the reduced plan is measured as 81 cm2. The actual (m2) of the survey is

    • Options
    • A. 10000
    • B. 6561
    • C. 1000
    • D. 656
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.