Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
The temperature indicating instrument in vehicles indicates the temperature of
Options- A. engine piston
- B. engine cylinder
- C. lubricating oil
- D. jacket cooling water
- Correct Answer
- jacket cooling water
- 1. An imbalance wheel during vehicle operation
Options- A. makes large noise when its heavy point hits the road surface
- B. deflects in the vehicle's longitudinal direction
- C. bounces vertically or deflects from side to side (as seen from front or rear)
- D. creates a standing wave Discuss
- 2. The device for smoothening out the power impulses from the engine is called
Options- A. clutch
- B. differential
- C. flywheel
- D. torque converter Discuss
- 3. Thinner is added to the paint in order to
Options- A. make pigments and resin mix easily
- B. make paint film hard
- C. optimise its viscosity
- D. none of these Discuss
- 4. In vehicles with tilt steering, the steering column is pivoted in
Options- A. upper bracket
- B. lower bracket
- C. tilt bracket
- D. steering yoke joint Discuss
- 5. A four-cylinder engine has a capacity of 2.4 litres. The swept volume of one cylinder is
Options- A. 400 cm3
- B. 600 cm3
- C. 1200 cm3
- D. 2400 cm3 Discuss
- 6. The main function of an exhaust muffler is the
Options- A. optimisation of exhaust efficiency
- B. reduction of exhaust noise
- C. reduction of nitrogen oxide in the exhaust gases
- D. reduction of the exhaust gas volume Discuss
- 7. The ease with which petrol vapourizes is called its
Options- A. oxidation
- B. octane number
- C. volatility
- D. cetane number Discuss
- 8. The self ignition temperature of Diesel as compared to petrol is
Options- A. higher
- B. lower
- C. same
- D. depends on fuel quality Discuss
- 9. The reconditioning process used to give cylinder bore surfaces a cross-hatch pattern, is known as
Options- A. honing
- B. porous plating
- C. boring
- D. shot peening Discuss
- 10. The caster is called positive when the top of the king pin is inclined to the
Options- A. rear of the vehicle
- B. front of the vehicle
- C. left of the vehicle
- D. right of the vehicle Discuss
Automobile Engineering problems
Search Results
Correct Answer: bounces vertically or deflects from side to side (as seen from front or rear)
Correct Answer: flywheel
Correct Answer: optimise its viscosity
Correct Answer: lower bracket
Correct Answer: 600 cm3
Correct Answer: reduction of exhaust noise
Correct Answer: volatility
Correct Answer: lower
Correct Answer: honing
Correct Answer: rear of the vehicle
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.