Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
Piercing is an operation of cutting
Options- A. a cylindrical hole in a sheet of metal by the punch and the die
- B. a hole (other than cylindrical) in a sheet of metal by the punch and the die
- C. a flat sheet to the desired shape
- D. a number of holes evenly spaced in a regular pattern on a sheet of metal
- Correct Answer
- a hole (other than cylindrical) in a sheet of metal by the punch and the die
- 1. A basic shaft is one whose
Options- A. lower deviation is zero
- B. upper deviation is zero
- C. lower and upper deviations are zero
- D. none of these Discuss
- 2. In order to deliver molten metal from pouring basin to gate, a __________ is used.
Options- A. riser
- B. sprue
- C. core Discuss
- 3. V-block is used to
Options- A. check the trueness of flat surfaces
- B. locate centres of round rods
- C. check the surface roughness
- D. none of these Discuss
- 4. Scribing block is used to
Options- A. hold the round bars during marking
- B. check the trueness of flat surfaces
- C. locate the centres of round bars
- D. check the surface roughness Discuss
- 5. In electric resistance welding, pressure is applied just after the completion of current.
Options- A. True
- B. False Discuss
- 6. The increase in hardness due to cold working, is called
Options- A. age-hardening
- B. work-hardening
- C. induction hardening
- D. flame hardening Discuss
- 7. In permanent mould casting method
Options- A. molten metal is poured in a metallic mould, retained in the mould long enough for the outer skin to solidify and finally mould is turned over to remove molten metal still in molten condition
- B. molten metal is poured and allowed to solidify while the mould is revolving
- C. molten metal is forced into mould under high pressure
- D. none of the above Discuss
- 8. In back-hand welding, the angle between the welding rod and the work is __________ as compared to fore-hand welding.
Options- A. same
- B. less
- C. more Discuss
- 9. When a pattern is made in three parts, the top part, is known as a
Options- A. drag
- B. cheek
- C. cope
- D. none of these Discuss
- 10. Which of the following welding method uses a pool of molten metal?
Options- A. Carbon arc welding
- B. Submerged arc welding
- C. TIG arc welding
- D. MIG arc welding Discuss
Workshop Technology problems
Search Results
Correct Answer: upper deviation is zero
Correct Answer: sprue
Correct Answer: none of these
Correct Answer: locate the centres of round bars
Correct Answer: True
Correct Answer: work-hardening
Correct Answer: none of the above
Correct Answer: same
Correct Answer: cope
Correct Answer: Submerged arc welding
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.