Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
Loam sand is a mixture of
Options- A. 30% sand and 70% clay
- B. 50% sand and 50% clay
- C. 70% sand and 30% clay
- D. 90% sand and 10% clay
- Correct Answer
- 50% sand and 50% clay
- 1. The torch used for oxygen cutting is same as for oxy-acetylene welding.
Options- A. Yes
- B. No Discuss
- 2. A casting defect which occurs near the ingates as rough lumps on the surface of a casting is known as
Options- A. shift
- B. sand wash
- C. swell
- D. scab Discuss
- 3. A sand employed on the faces of the pattern before moulding, is called
Options- A. green sand
- B. dry sand
- C. loam sand
- D. parting sand Discuss
- 4. The most preferred process for casting gas turbine blades is
Options- A. die casting
- B. shell moulding
- C. investment moulding
- D. sand casting Discuss
- 5. In a cold chamber die casting machine
Options- A. melting pot is separate from the machine
- B. melting pot is an integral part of the machine
- C. melting pot may have any location
- D. low temperature and pressure is used Discuss
- 6. In a cold chamber die casting machine, a measured quantity of molten metal is brought in a ladle from the melting pot to a chamber and forced into the closed die-section by applying hydraulic pressure upon the plunger.
Options- A. Correct
- B. Incorrect Discuss
- 7. The operation of cutting a cylindrical hole in a sheet of metal by the punch and die is called
Options- A. shearing
- B. piercing
- C. punching
- D. blanking Discuss
- 8. The minimum size of a bloom is
Options- A. 5 cm x 5 cm
- B. 10 cm x 10 cm
- C. 15 cm x 15 cm
- D. 20 cm x 20 cm Discuss
- 9. A three high rolling mill consists of three rolls placed one above the other. Which of the following statement is correct?
Options- A. The upper and middle rolls rotate in the same direction whereas the bottom roll rotates in opposite direction.
- B. The upper and bottom rolls rotate in the same direction whereas the middle roll rotate in opposite direction.
- C. The bottom and middle roll rotate in the same direction.
- D. any one of the above Discuss
- 10. In fore-hand welding, the weld is made
Options- A. from left to right
- B. from right to left
- C. first from left to right and then from right to left
- D. either from left to right or from right to left Discuss
Workshop Technology problems
Search Results
Correct Answer: No
Correct Answer: sand wash
Correct Answer: parting sand
Correct Answer: shell moulding
Correct Answer: melting pot is separate from the machine
Correct Answer: Correct
Correct Answer: piercing
Correct Answer: 15 cm x 15 cm
Correct Answer: The upper and bottom rolls rotate in the same direction whereas the middle roll rotate in opposite direction.
Correct Answer: from right to left
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.