logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Automobile Engineering Comments

  • Question
  • In a unit type body (frameless body) design, the sheet metal parts are welded together, forming a frame work to which outer skin is attached.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 


  • Automobile Engineering problems


    Search Results


    • 1. A zinc diffusion process is called

    • Options
    • A. galvanising
    • B. anodising
    • C. parkerising
    • D. sherardizing
    • Discuss
    • 2. The accuracy of micrometers, calipers, dial indicators can be checked by a

    • Options
    • A. feeler gauge
    • B. slip gauge
    • C. ring gauge
    • D. plug gauge
    • Discuss
    • 3. The type of file used for a wood work is

    • Options
    • A. single-cut file
    • B. double cut file
    • C. rasp-cut file
    • D. any one of these
    • Discuss
    • 4. In __________ welding, the weld may be made either from left to right or from right to left.

    • Options
    • A. fore-hand
    • B. back-hand
    • C. vertical
    • Discuss
    • 5. The ferrous metals require more machining allowance than non-ferrous metals.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. The tilting of the front wheels away from the vertical, when viewed from the front of the car, is called

    • Options
    • A. camber
    • B. caster
    • C. toe-in
    • D. toe-out
    • Discuss
    • 7. The operation of removing trapped air from the hydraulic braking system is known as

    • Options
    • A. trapping
    • B. tapping
    • C. bleeding
    • D. cleaning
    • Discuss
    • 8. Incorrect steering axis inclination (S.A.I.) causes

    • Options
    • A. tendency to assume toe-out orientation
    • B. generation of a braking effect at tight corners
    • C. poor recovery of the steering wheel after making a turn
    • D. the vehicle to pull to the side of lesser inclination
    • Discuss
    • 9. The aluminium alloy is used in cylinder blocks because

    • Options
    • A. it is lighter and have good heat dissipation characteristics
    • B. material cost is low
    • C. it does not require any cylinder liners
    • D. the piston is also made of aluminium alloy
    • Discuss
    • 10. The compression ratio in petrol engine is kept less than in Diesel engine because

    • Options
    • A. it makes petrol engines lighter
    • B. higher or equivalent compression ratio in petrol engines is not possible due to pre-ignition
    • C. less compression ratio gives better performance
    • D. it is just customary to have less compression ratio in petrol engines
    • Discuss


    Comments

    There are no comments.

Enter a new Comment