Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
- Question
The thickness of a thin cylindrical shell with hemispherical ends is __________ that of spherical ends.
Options- A. equal to
- B. more than
- C. less than
- Correct Answer
- more than
- 1. The tensile strength of ductile materials is __________ its compressive strength.
Options- A. equal to
- B. less than
- C. greater than Discuss
- 2. The assumption made in the theory of the reinforced cement concrete beam is that
Options- A. all the tensile stresses are taken up by the steel reinforcement only
- B. there is a sufficient bond between steel and concrete
- C. the steel and concrete are stressed within its elastic limit
- D. all of the above Discuss
- 3. The direct stress induced in a long column is __________ as compared to bending stress.
Options- A. same
- B. more
- C. less
- D. negligible Discuss
- 4. The steel bars in a reinforced cement concrete beam are embedded __________ of the beam.
Options- A. in the centre
- B. near the bottom
- C. near the top
- D. at any position Discuss
- 5. Two beams, one of circular cross-section and the other of square cross-section, have equal areas of cross-sections. When these beams are subjected to bending,
Options- A. both beams are equally economical
- B. square beam is more economical
- C. circular beam is more economical
- D. none of these Discuss
- 6. The strain energy stored in a body due to shear stress, is (where ? = Shear stress, C = Shear modulus, and V = Volume of the body)
Options- A.
- B.
- C.
- D.
Discuss
- 7. Hook's law holds good up to
Options- A. yield point
- B. elastic limit
- C. plastic limit
- D. breaking point Discuss
- 8. The unit of stress in S.I. units is
Options- A. N/mm2
- B. kN/mm2
- C. N/m2
- D. any one of these Discuss
- 9. When there is a sudden increase or decrease in shear force diagram between any two points, it indicates that there is a
Options- A. point load at the two points
- B. no loading between the two points
- C. uniformly distributed load between the two points
- D. uniformly varying load between the two points Discuss
- 10. The extension of a circular bar tapering uniformly from diameter d1 at one end to diameter d2 at the other end, and subjected to an axial pull of P is __________ the extension of a circular bar of diameter d1 d2 subjected to the same load P.
Options- A. equal to
- B. less than
- C. greater than Discuss
Strength of Materials problems
Search Results
Correct Answer: greater than
Correct Answer: all of the above
Correct Answer: negligible
Correct Answer: near the bottom
Correct Answer: square beam is more economical
Correct Answer:
Correct Answer: elastic limit
Correct Answer: any one of these
Correct Answer: point load at the two points
Correct Answer: equal to
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.