logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • For riveting, the size of hole drilled in plates is __________ shank diameter of rivet.


  • Options
  • A. equal to
  • B. less than
  • C. greater than

  • Correct Answer
  • greater than 


  • Strength of Materials problems


    Search Results


    • 1. The shear force of a cantilever beam of length l and carrying a gradually varying load from zero at the free end and w per unit length at the fixed end is __________ at the fixed end.

    • Options
    • A. zero
    • B. wl/4
    • C. wl/2
    • D. wl
    • Discuss
    • 2. The springs in cars are used to store strain energy.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 3. The section modulus (Z) of a beam is given by

    • Options
    • A. I/y
    • B. I.y
    • C. y/I
    • D. M/I
    • Discuss
    • 4. The ductility of the material __________ with the decrease in percentage elongation of a specimen under tensile test.

    • Options
    • A. increases
    • B. decreases
    • C. remains same
    • Discuss
    • 5. The pull required to shear off a rivet, in double shear, per pitch length is

    • Options
    • A. ?/4 x d2 x ?t
    • B. ?/4 x d2 x ?
    • C. ?/2 x d2 x ?t
    • D. ?/2 x d2 x ?
    • Discuss
    • 6. If the modulus of elasticity for a given material is twice its modulus of rigidity, then bulk modulus is equal to

    • Options
    • A. 2C
    • B. 3C
    • C.
    • D.
    • Discuss
    • 7. When a body is subjected to two equal and opposite pulls, as a result of which the body tends to extend its length, the stress and strain induced is

    • Options
    • A. compressive stress, tensile strain
    • B. tensile stress, compressive strain
    • C. tensile stress, tensile strain
    • D. compressive stress, compressive strain
    • Discuss
    • 8. The stress developed in the material without any permanent set is called

    • Options
    • A. elastic limit
    • B. yield stress
    • C. ultimate stress
    • D. breaking stress
    • Discuss
    • 9. Two shafts 'A' and 'B' are made of same material. The shaft 'A' is of diameter D and shaft 'B' is of diameter D/2. The strength of shaft 'B' is __________ as that of shaft 'A'

    • Options
    • A. one-eighth
    • B. one-fourth
    • C. one-half
    • D. four times
    • Discuss
    • 10. The Young's modulus of a material is 125 GPa and Poissons ratio is 0.25. The modulus of rigidity of me material is

    • Options
    • A. 30 GPa
    • B. 50 GPa
    • C. 80 GPa
    • D. 100 GPa
    • Discuss


    Comments

    There are no comments.

Enter a new Comment