logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Industrial Engineering and Production Management Comments
  • Question

  • PERT is a project planning and control technique.


  • Options
  • A. Yes
  • B. No

  • Correct Answer
  • Yes 

    • Industrial Engineering and Production Management problems

    Search Results

    • 1. Actual performance of a task is called

    • Options
    • A. an event
    • B. an activity
    • C. a duration
    • D. none of these
      • Discuss
    • 2. Process layout is also known as

    • Options
    • A. analyticallayout
    • B. synthetic layout
    • C. static product layout
    • D. none of these
      • Discuss
    • 3. Which of the following wage incentive plan is applied to all workers?

    • Options
    • A. Halsey plan
    • B. Gantt plan
    • C. Emerson's efficiency plan
    • D. Rowan plan
      • Discuss
    • 4. The interchangeability can be achieved by

    • Options
    • A. standardisation
    • B. better process planning
    • C. bonus plan
    • D. better product planning
      • Discuss
    • 5. The most suitableincentive plan for the maintenance section of an industry will be

    • Options
    • A. piece rate system
    • B. group incentive plan
    • C. profit sharing plans
    • D. simplification
      • Discuss
    • 6. In a simple bending theory, one of the assumption is that the material of the beam is isotropic. This assumption means that the

    • Options
    • A. normal stress remains constant in all directions
    • B. normal stress varies linearly in the material
    • C. elastic constants are same in all the directions
    • D. elastic constants varies linearly in the material
      • Discuss
    • 7. For the beam shown in the below figure, the shear force at A is equal to

    • Options
    • A. wl/6
    • B. wl/3
    • C. wl
    • D. 2 wl/3
      • Discuss
    • 8. A welded joint as compared to a riveted joint has __________ strength.

    • Options
    • A. same
    • B. less
    • C. more
      • Discuss
    • 9. A body is subjected to two normal stresses 20 kN/m2 (tensile) and 10 kN/m2 (compressive) acting perpendicular to each other. The maximum shear stress is

    • Options
    • A. 5 kN/m2
    • B. 10 kN/m2
    • C. 15 kN/m2
    • D. 20 kN/m2
      • Discuss
    • 10. When a cantilever beam is loaded at its free end, the maximum compressive stress shall develop at

    • Options
    • A. bottom fibre
    • B. top fibre
    • C. neutral axis
    • D. centre of gravity
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.