Discussion
Home ‣ Mechanical Engineering ‣ Industrial Engineering and Production Management See What Others Are Saying!
- Question
When slack of an activity is positive
Options- A. it represents a situation where extra resources are available and the completion of project is not delayed
- B. it represents that a programme falls behind schedule and additional resources are required to complete the project in time
- C. the activity is critical and any delay in its performance will delay the completion of whole project
- D. any one of the above
- Correct Answer
- it represents a situation where extra resources are available and the completion of project is not delayed
- 1. The total pressure exerted by the mixture of air and water vapour is equal to the sum of pressures which each constituent would exert, if it occupied the same space by itself. This statement is called
Options- A. Kinetic theory of gases
- B. Newton's law of gases
- C. Dalton's law of partial pressures
- D. Avogadro's hypothesis Discuss
- 2. In a single threaded worm and worm wheel, the number of teeth on the worm is 50. The diameter of the effort wheel is 100 mm and that of load drum is 50 mm. The velocity ratio is
Options- A. 50
- B. 100
- C. 150
- D. 200 Discuss
- 3. A water tank contains 1.3 m deep water. The pressure exerted by the water per metre length of the tank is
Options- A. 2.89 kN
- B. 8.29 kN
- C. 9.28 kN
- D. 28.9 kN Discuss
- 4. Positive camber is used to compensate for wheels tilting inward due to the weight of the vehicle.
Options- A. Yes
- B. No Discuss
- 5. Locomotive boiler produces steam at a very high rate.
Options- A. Yes
- B. No Discuss
- 6. The leakage in a refrigeration system using ammonia is detected by
Options- A. halide torch
- B. sulphur sticks
- C. soap and water
- D. all of these Discuss
- 7. The oxidising flame is similar to neutral flame but the inner cone is less luminous and shorter.
Options- A. Yes
- B. No Discuss
- 8. If the sand is too fine, its permeability will be high.
Options- A. True
- B. False Discuss
- 9. When the nozzle operates with the maximum mass flow, the nozzle is said to be
Options- A. choked
- B. underdamping
- C. overdamping
- D. none of these Discuss
- 10. In a footstep bearing, if the speed of the shaft is doubled, then the torque required to overcome the viscous resistance will be
Options- A. double
- B. four times
- C. eight times
- D. sixteen times Discuss
More questions
Correct Answer: Dalton's law of partial pressures
Correct Answer: 100
Correct Answer: 8.29 kN
Correct Answer: Yes
Correct Answer: Yes
Correct Answer: sulphur sticks
Correct Answer: Yes
Correct Answer: False
Correct Answer: choked
Correct Answer: double
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.