Discussion
Home ‣ Mechanical Engineering ‣ Compressors, Gas Dynamics and Gas Turbines Comments
- Question
The process, which causes the air to enter the impeller blades of a centrifugal compressor at __________ velocity (without effecting the mass of air to flow and velocity of flow) is known as prewhirl.
Options- A. reduced
- B. increased
- Correct Answer
- reduced
- 1. The pressure of air at the beginning of the compression stroke is __________ the atmospheric pressure.
Options- A. equal to
- B. less than
- C. more than Discuss
- 2. In a single stage, single acting reciprocating air compressor, without clearance, the workdone on the air during isentropic compression is __________ the heat required to raise the temperature of air from T1 to T2 at a constant pressure.
Options- A. equal to
- B. less than
- C. greater than Discuss
- 3. Which of the following statement is correct relating to rocket engines?
Options- A. The combustion chamber in a rocket engine is directly analogous to the reservoir of a super sonic wind tunnel
- B. The stagnation conditions exist at the combustion chamber
- C. The exit velocities of exhaust gases are much higher than those in jet engine
- D. all of the above Discuss
- 4. For maximum work, the reheating should be done to an intermediate pressure of (where p1 = Maximum pressure, and p2 = Minimum pressure)
Options- A.
- B.
- C.
- D. p1p2 Discuss
- 5. Free air is the air at atmospheric conditions at any specific location.
Options- A. True
- B. False Discuss
- 6. The axial flow compressor is preferred in air-craft gas turbines because of
Options- A. low frontal area
- B. higher thrust
- C. high pressure rise
- D. none of these Discuss
- 7. Which of the following statement is correct as regard to centrifugal compressors?
Options- A. The flow of air is parallel to the axis of the compressor.
- B. The static pressure of air in the impeller increases in order to provide centripetal force on the air.
- C. The impeller rotates at high speeds.
- D. The maximum efficiency is higher than multi-stage axial flow compressors. Discuss
- 8. The mass of gas turbine per kW developed is about __________ as that of an I.C. engine.
Options- A. same
- B. one-half
- C. one-fourth
- D. one-sixth Discuss
- 9. In a turbo jet engine, subsequent to heat addition to compressed air, to get the power output, the working substance is expanded in
Options- A. exit nozzle, which is a constant volume process
- B. exit nozzle, which is essentially an isentropic process
- C. turbine blades, which is a constant volume process
- D. turbine blades, which is essentially an isentropic process Discuss
- 10. The performance of air compressor at high altitudes will be __________ as compared to that at sea level.
Options- A. same
- B. lower
- C. higher Discuss
Compressors, Gas Dynamics and Gas Turbines problems
Search Results
Correct Answer: less than
Correct Answer: equal to
Correct Answer: all of the above
Correct Answer: p1p2
Correct Answer: True
Correct Answer: low frontal area
Correct Answer: The static pressure of air in the impeller increases in order to provide centripetal force on the air.
Correct Answer: one-sixth
Correct Answer: turbine blades, which is essentially an isentropic process
Correct Answer: lower
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.