Discussion
Home ‣ Technical Drawing ‣ Piping Drawings Comments
- Question
This type of pipe is commonly used for water or gas service, and also as soil pipe:
Options- A. PVC
- B. Copper
- C. Steel
- D. Cast-iron
- Correct Answer
- Cast-iron
- 1. This type of drawing shows two lines representing the pipe diameter:
Options- A. Single-line
- B. Double-line
- C. Standard piping
- D. Centerline piping Discuss
- 2. These types of pipes are generally connected with bell and spigot joints or flanged joints:
Options- A. Soil and waste
- B. Water and gas
- C. Water and steam
- D. Gas and soil Discuss
- 3. This type of pipe is commonly used for water, steam, oil, and gas:
Options- A. Wrought iron or copper
- B. PVC or steel
- C. Steel or wrought iron
- D. Copper or PVC Discuss
- 4. This type of structural steel drawing shows all dimensions necessary for fabrication:
Options- A. Shop drawings
- B. Design drawings
- C. Weldment drawings
- D. Application drawings Discuss
- 5. This type of weld is the most common in structural steel fabrication:
Options- A. Fillet weld
- B. Beam weld
- C. Rivet weld
- D. Structural weld Discuss
- 6. When dimensioning piping drawings, you give the lengths of all runs of this type:
Options- A. Straight
- B. Angular
- C. Filleted
- D. Transverse Discuss
- 7. This is used in applications for nonferrous construction:
Options- A. Copper tubing
- B. Steel pipe
- C. PVC pipe
- D. Iron tubing Discuss
- 8. In this type of drawing, vertical pipes may be revolved into the horizontal plane:
Options- A. Standard view
- B. Elevation view
- C. Transverse piping
- D. Developed piping Discuss
- 9. A line with a tapering width can be easily created by using the ________ tool.
Options- A. circle
- B. eclipse
- C. line
- D. polyline Discuss
- 10. If you use the absolute coordinate system to create a line from a starting point of 0, 0 8 units on the X axis and 5 units on the Y axis you enter ________ for the second point.
Options- A. 8,5
- B. 5,8
- C. 0,8
- D. 5,0 Discuss
Piping Drawings problems
Search Results
Correct Answer: Double-line
Correct Answer: Water and gas
Correct Answer: Steel or wrought iron
Correct Answer: Shop drawings
Correct Answer: Fillet weld
Correct Answer: Straight
Correct Answer: Copper tubing
Correct Answer: Developed piping
Correct Answer: polyline
Correct Answer: 8,5
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.