Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Code Converters and Multiplexers
Why is the Gray code more practical to use when coding the position of a rotating shaft?
All digits change between counts.
Two digits change between counts.
Only one digit changes between counts.
Correct Answer:
Only one digit changes between counts.
← Previous Question
Next Question→
More Questions from
Code Converters and Multiplexers
Exclusive-AND gates are needed for conversions between Gray code and binary code.
A BCD is used for communication between a computer and a human being because it is too easy to deal with arithmetically.
The microcontroller needs to use only three input lines to monitor eight separate points.
The 74154 is a 1-of-16 decoder. It accepts a 4-bit binary input.
In a priority encoder, the input with the highest priority is represented on the output.
Before you can make a design you must decide if you want an active-HIGH output.
The basic comparator evaluates two binary strings bit by bit and always outputs a 1.
A demultiplexer takes a dual input data value and routes it to one of several outputs.
In a multiplexer, the data select control inputs are responsible for determining which data input is selected to be transmitted to the data output line.
The digit bus and display bus are each just a common set of conductors shared by the digit storage registers and display segments.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments