Discussion
Home ‣ Digital Electronics ‣ Digital Concepts Comments
- Question
A classification of ICs with complexities of 12 to 100 equivalent gates on a chip is known as ________.
Options- A. SSI
- B. MSI
- C. LSI
- D. VLSI
- Correct Answer
- MSI
- 1. A common instrument used in troubleshooting a digital circuit is a(n) ________.
Options- A. logic probe
- B. oscilloscope
- C. pulser
- D. all of the above Discuss
- 2. Any number with an exponent of zero is equal to:
Options- A. zero
- B. one
- C. that number
- D. ten Discuss
- 3. An encoder converts ________.
Options- A. noncoded information into coded form
- B. coded information into noncoded form
- C. HIGHs to LOWs
- D. LOWs to HIGHs Discuss
- 4. The parallel transmission of digital data:
Options- A. is much slower than the serial transmission of data.
- B. requires only one signal line between sender and receiver.
- C. requires as many signal lines between sender and receiver as there are data bits.
- D. is less expensive than the serial method of data transmission. Discuss
- 5. Give the decimal value of binary 10000110.
Options- A. 13410
- B. 14410
- C. 11010
- D. 12610 Discuss
- 6. The holes through a PC board are ________.
Options- A. smaller with SMT than with through-hole mounting
- B. larger with SMT than with through-hole mounting
- C. the same size as with through-hole mounting
- D. usually unnecessary Discuss
- 7. Which of the following is not an analog device?
Options- A. Thermocouple
- B. Current flow in a circuit
- C. Light switch
- D. Audio microphone Discuss
- 8. What are the symbols used to represent digits in the binary number system?
Options- A. 0,1
- B. 0,1,2
- C. 0 through 8
- D. 1,2 Discuss
- 9. A DAC changes ________.
Options- A. an analog signal into digital data
- B. digital data into an analog signal
- C. digital data into an amplified signal
- D. none of the above Discuss
- 10. What is the typical invalid voltage for a binary signal?
Options- A. 0.7?2.8 volts
- B. 0.8?3 volts
- C. 0.8?2 volts
- D. 0.7?2.5 volts Discuss
Digital Concepts problems
Search Results
Correct Answer: all of the above
Correct Answer: one
Correct Answer: noncoded information into coded form
Correct Answer: requires as many signal lines between sender and receiver as there are data bits.
Correct Answer: 13410
Correct Answer: the same size as with through-hole mounting
Correct Answer: Light switch
Correct Answer: 0,1
Correct Answer: digital data into an analog signal
Correct Answer: 0.8?2 volts
Comments
There are no comments.More in Digital Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.