logo

CuriousTab

CuriousTab

Discussion

Home ‣ Electronics ‣ Testing and Troubleshooting Comments
  • Question

  • Which test equipment best allows a comparison between input and output signals?


  • Options
  • A. an oscilloscope
  • B. a logic probe
  • C. a spectrum analyzer
  • D. a multitrace oscilloscope

  • Correct Answer
  • a multitrace oscilloscope 

    • Testing and Troubleshooting problems

    Search Results

    • 1. Which device would best aid in shorted track detection?

    • Options
    • A. multimeter
    • B. current tracer
    • C. logic pulser
    • D. oscilloscope
      • Discuss
    • 2. The use of a multimeter with digital circuits allows the measurement of:

    • Options
    • A. pulse width
    • B. voltage or resistance
    • C. current
    • D. pulse trains
      • Discuss
    • 3. The determination of a digital signal's frequency and waveshape is best accomplished with which test equipment?

    • Options
    • A. an oscilloscope
    • B. a multimeter
    • C. a spectrum analyzer
    • D. a frequency generator
      • Discuss
    • 4. The time needed for a pulse to increase from 10% to 90% of its amplitude defines:

    • Options
    • A. pulse width
    • B. propagation delay
    • C. rise time
    • D. duty cycle
      • Discuss
    • 5. The duty cycle of a pulse is determined by which formula?

    • Options
    • A. Duty Cycle =
    • B. Duty Cycle =
    • C. Duty Cycle =
    • D. Duty Cycle =
      • Discuss
    • 6. A series of gradually decreasing sine wave oscillations is called:

    • Options
    • A. ringing
    • B. slew
    • C. overshooting
    • D. undershooting
      • Discuss
    • 7. The truth table for an S-R flip-flop has how many VALID entries?

    • Options
    • A. 3
    • B. 1
    • C. 4
    • D. 2
      • Discuss
    • 8. One example of the use of an S-R flip-flop is as a(n):

    • Options
    • A. transition pulse generator
    • B. astable oscillator
    • C. racer
    • D. switch debouncer
      • Discuss
    • 9. The 555 timer can be used in which of the following configurations?

    • Options
    • A. astable, monostable
    • B. monostable, bistable
    • C. astable, toggled
    • D. bistable, tristable
      • Discuss
    • 10. The equation for the output frequency of a 555 timer operating in the astable mode is: .
      What value of C1 will be required if R1 = 1 kΩ, R2 = 1 kΩ, and f = 1 kHz?

    • Options
    • A. 0.33 µF
    • B. 0.48 µF
    • C. 480 µF
    • D. 33 nF
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.