logo

CuriousTab

CuriousTab

Discussion


Home Electronics Testing and Troubleshooting See What Others Are Saying!
  • Question
  • Measurement of pulse width should be taken at a 50% mean of the:


  • Options
  • A. overshoot and undershoot
  • B. rise and fall
  • C. damping and ringing
  • D. leading and trailing amplitude

  • Correct Answer
  • rise and fall 


  • More questions

    • 1. 

      Calculate the phase angle in the given circuit.


    • Options
    • A. 0°
    • B. 90°
    • C. 22.52°
    • D. 67.48°
    • Discuss
    • 2. 

      The current lags the voltage in the given circuit.


    • Options
    • A. True
    • B. False
    • Discuss
    • 3. This is a PNP transistor.


    • Options
    • A. True
    • B. False
    • Discuss
    • 4. What is a circuit that produces short-duration spikes?

    • Options
    • A. A trigger pulse generator
    • B. An RL integrator
    • C. A timing circuit
    • D. A pulse waveform-to-dc converter
    • Discuss
    • 5. If current through a resistance is halved

    • Options
    • A. the resistance is halved
    • B. the voltage is halved
    • C. the voltage doubles
    • D. none of the above
    • Discuss
    • 6. With the E-MOSFET, when gate input voltage is zero, drain current is:

    • Options
    • A. at saturation
    • B. zero
    • C. IDSS
    • D. widening the channel
    • Discuss
    • 7. The device that would best aid in open track detection is a(n) ________.

    • Options
    • A. multimeter
    • B. current tracer
    • C. logic probe
    • D. oscilloscope
    • Discuss
    • 8. What is the zero-voltage switch used for?

    • Options
    • A. To reduce radiation of high frequencies during turn-on of a high current to a load
    • B. To control low-voltage circuits
    • C. To provide power to a circuit when power is lost
    • D. For extremely low-voltage applications
    • Discuss
    • 9. In order for a logic probe to operate, its red and black leads must first be connected to a ________.

    • Options
    • A. logic clip
    • B. HIGH or TRUE signal
    • C. power source
    • D. logic pulser
    • Discuss
    • 10. If the resistance in a circuit with constant voltage increases, the current will

    • Options
    • A. increase
    • B. decrease
    • C. stay the same
    • D. Not enough information
    • Discuss


    Comments

    There are no comments.

Enter a new Comment