Discussion
Home ‣ Electronics ‣ Standard Logic Devices (SLD) Comments
- Question
A digital logic device used as a buffer should have what input/output characteristics?
Options- A. high input impedance and high output impedance
- B. low input impedance and high output impedance
- C. low input impedance and low output impedance
- D. high input impedance and low output impedance
- Correct Answer
- high input impedance and low output impedance
- 1. What quantities must be compatible when interfacing two different logic families?
Options- A. only the currents
- B. both the voltages and the currents
- C. only the voltages
- D. both the power dissipation and the impedance Discuss
- 2. A TTL totem pole circuit is designed so that the output transistors are:
Options- A. always on together
- B. providing phase splitting
- C. providing voltage regulation
- D. never on together Discuss
- 3. When an IC has two rows of parallel connecting pins, the device is referred to as:
Options- A. a QFP
- B. a DIP
- C. a phase splitter
- D. CMOS Discuss
- 4. The problem of interfacing IC logic families that have different supply voltages (VCCs) can be solved by using a:
Options- A. level-shifter
- B. tri-state shifter
- C. translator
- D. level-shifter or translator Discuss
- 5. What is the standard TTL noise margin?
Options- A. 5.0 V
- B. 0.2 V
- C. 0.8 V
- D. 0.4 V Discuss
- 6. The range of a valid LOW input is:
Options- A. 0.0 V to 0.4 V
- B. 0.4 V to 0.8 V
- C. 0.4 V to 1.8 V
- D. 0.4 V to 2.4 V Discuss
- 7. The time needed for an output to change as the result of an input change is known as:
Options- A. noise immunity
- B. fanout
- C. propagation delay
- D. rise time Discuss
- 8. The use of triggered sweep when using an oscilloscope provides more accuracy in which area?
Options- A. frequency
- B. amplitude
- C. graticule activity
- D. timing Discuss
- 9. What is the next step after discovering a faulty gate within an IC?
Options- A. repair the gate
- B. resolder the tracks
- C. replace the IC involved
- D. recheck the power source Discuss
- 10. A +5 V PCB power source that has been "pulled down" to a +3.4 V level may be due to:
Options- A. a circuit open
- B. a faulty regulator
- C. the half-split method
- D. a circuit short Discuss
Standard Logic Devices (SLD) problems
Search Results
Correct Answer: both the voltages and the currents
Correct Answer: never on together
Correct Answer: a DIP
Correct Answer: level-shifter or translator
Correct Answer: 0.4 V
Correct Answer: 0.4 V to 0.8 V
Correct Answer: propagation delay
Correct Answer: timing
Correct Answer: replace the IC involved
Correct Answer: a circuit short
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.