Discussion
Home ‣ Electronics ‣ Field Effect Transistors (FET) Comments
- Question
When not in use, MOSFET pins are kept at the same potential through the use of:
Options- A. shipping foil
- B. nonconductive foam
- C. conductive foam
- D. a wrist strap
- Correct Answer
- conductive foam
- 1. The transconductance curve of a JFET is a graph of:
Options- A. IS versus VDS
- B. IC versus VCE
- C. ID versus VGS
- D. ID × RDS Discuss
- 2. A MOSFET has how many terminals?
Options- A. 2 or 3
- B. 3
- C. 4
- D. 3 or 4 Discuss
- 3. D-MOSFETs are sometimes used in series to construct a cascode high-frequency amplifier to overcome the loss of:
Options- A. low output impedance
- B. capacitive reactance
- C. high input impedance
- D. inductive reactance Discuss
- 4. With a 30-volt VDD, and an 8-kilohm drain resistor, what is the E-MOSFET Q point voltage, with ID = 3 mA?
Options- A. 6 V
- B. 10 V
- C. 24 V
- D. 30 V Discuss
- 5. The common-source JFET amplifier has:
Options- A. a very high input impedance and a relatively low voltage gain
- B. a high input impedance and a very high voltage gain
- C. a high input impedance and a voltage gain less than 1
- D. no voltage gain Discuss
- 6. Using voltage-divider biasing, what is the voltage at the gate VGS?
Options- A. 5.2 V
- B. 4.2 V
- C. 3.2 V
- D. 2.2 V Discuss
- 7. The type of bias most often used with E-MOSFET circuits is:
Options- A. constant current
- B. drain-feedback
- C. voltage-divider
- D. zero biasing Discuss
- 8. When VGS = 0 V, a JFET is:
Options- A. saturated
- B. an analog device
- C. an open switch
- D. cut off Discuss
- 9. When applied input voltage varies the resistance of a channel, the result is called:
Options- A. saturization
- B. polarization
- C. cutoff
- D. field effect Discuss
- 10. Which JFET configuration would connect a high-resistance signal source to a low-resistance load?
Options- A. source follower
- B. common-source
- C. common-drain
- D. common-gate Discuss
Field Effect Transistors (FET) problems
Search Results
Correct Answer: ID versus VGS
Correct Answer: 3 or 4
Correct Answer: high input impedance
Correct Answer: 6 V
Correct Answer: a very high input impedance and a relatively low voltage gain
Correct Answer: 5.2 V
Correct Answer: drain-feedback
Correct Answer: saturated
Correct Answer: field effect
Correct Answer: source follower
Comments
There are no comments.More in Electronics:
Programming
Copyright ©CuriousTab. All rights reserved.