logo

CuriousTab

CuriousTab

Discussion


Home Electronics Resistance and Power Comments

  • Question
  • A potentiometer has how many leads?


  • Options
  • A. 1
  • B. 2
  • C. 3
  • D. 4

  • Correct Answer



  • Resistance and Power problems


    Search Results


    • 1. Which formula shows a direct proportionality between power and voltage?

    • Options
    • A. V = IR
    • B. P = VI
    • C. P = IR
    • D. I = V/R
    • Discuss
    • 2. One advantage of a carbon film resistor over a carbon composition resistor is:

    • Options
    • A. less circuit noise
    • B. smaller size
    • C. higher wattage
    • D. poor tolerance
    • Discuss
    • 3. For P = V2/R, a decrease in resistance should produce:

    • Options
    • A. a decrease in power
    • B. an increase in ohms
    • C. an increase in power
    • D. a decrease in current
    • Discuss
    • 4. What type of resistors have a tolerance rating of 5% or greater?

    • Options
    • A. precision
    • B. SIP
    • C. general-purpose
    • D. wirewound
    • Discuss
    • 5. A conductor's cross-sectional area in circular mils for inch is:

    • Options
    • A. 500 cmils
    • B. 100,000 cmils
    • C. 1,000,000 cmils
    • D. 500,000,000 cmils
    • Discuss
    • 6. If a calculator display was "0.00263," what would this answer be in percent?

    • Options
    • A. 0.026%
    • B. 0.26%
    • C. 2.63%
    • D. 26.3%
    • Discuss
    • 7. A 33 kΩ resistor with a 20% tolerance checks out as ok with which of the following ohmmeter readings?

    • Options
    • A. 26400 ohms
    • B. 24183 ohms
    • C. 6600 ohms
    • D. 39970 ohms
    • Discuss
    • 8. A wire with a smaller cross-sectional area will produce:

    • Options
    • A. less heat
    • B. more conductance
    • C. less resistance
    • D. more heat
    • Discuss
    • 9. With Ohm's law, no change in resistance means that current and voltage will be:

    • Options
    • A. directly proportional
    • B. unable to produce energy
    • C. the same
    • D. inversely proportional
    • Discuss
    • 10. One problem with mechanically variable resistors is noticeable in audio circuits as:

    • Options
    • A. scratchy noise
    • B. lack of bass response
    • C. variable volume
    • D. too much treble response
    • Discuss


    Comments

    There are no comments.

Enter a new Comment